In extreme ultraviolet (EUV) sources, small tin droplets are scattered into the tin mist/disc under the irradiation of the pulsed laser to produce the EUV light. Small droplet size and large droplet spacing are required to suppress debris production to protect expensive collector mirrors. To this end, a tin-droplet generator with a capillary glass nozzle was designed and built to produce uniform tin droplet streams with the droplet diameter less than 50 μm. Meanwhile, a forced perturbation, generated by a sandwich piezoelectric transducer, was loaded into a liquid tin jet to manipulate the droplet spacing through a stepped rod. The mono-sized tin droplet streams with an average diameter of 42 μm were successfully produced both in the Rayleigh and the forced jet breakup regimes. A 2D axisymmetric model was proposed to reveal the influence of the velocity perturbation amplitude on jet breakup patterns at different wavelengths. An F*-λ* map was built and six different droplet breakup patterns were identified based on simulations. Numerical simulations indicated that the droplet spacing could be increased by providing extra momentum to droplets from the forced velocity perturbation. Finally, by increasing the velocity perturbation amplitude, the droplet spacing was increased from ~7 Dd to ~19 Dd without significantly increasing the droplet size. This work provides a novel approach to obtaining small mono-sized tin droplet streams with manipulable droplet spacing.
11 September 2024 in International Journal of Mechanical Sciences
The direct fabrication of micron-thickness patterned electronics consisting of patterned PVA films and CNT micropatterns still faces considerable challenges. Here, we demonstrated the integrated fabrication of PVA films of micron-thickness and CNT-based patterns by utilising micro-pen writing and drop-on-demand printing in sequence. Patterned PVA films of 1–5 μm in thickness were written first using proper micro-pen writing parameters, including the writing gap, the substrate moving velocity, and the working pressure. Then, CNT droplets were printed on PVA films that were cured at 55–65 °C for 3–15 min, resulting in neat CNT patterns. In addition, an inertia-pseudopartial wetting spreading model was established to release the dynamics of the droplet spreading process over thin viscoelastic films. Uniform and dense CNT lines with a porosity of 2.2% were printed on PVA substrates that were preprocessed at 55 °C for 9 min using a staggered overwriting method with the proper number of layers. Finally, we demonstrated the feasibility of this hybrid printing method by printing a patterned PVA-CNT film and a micro-ribbon. This study provides a valid method for directly fabricating micron-thickness PVA-CNT electronics. The proposed method can also provide guidance on the direct writing of other high-molecular polymer materials and printing inks of other nanosuspensions.
13 September 2025 in International Journal of Mechanical Sciences