A novel ultraviolet (UV) optical fiber sensor (UVOFS) based on the scintillating material La₂O₂S:Eu has been designed, tested, and its performance compared with other scintillating materials and other conventional UV detectors. The UVOFS is based on PMMA (polymethyl methacrylate) optical fiber which includes a scintillating material. Scintillating materials provide a unique opportunity to measure UV light intensity even in the presence of strong electromagnetic interference. Five scintillating materials were compared in order to select the most appropriate one for the UVOFS. The characteristics of the sensor are reported, including a highly linear response to radiation intensity, reproducibility, temperature response, and response time (to pulsed light) based on emission from a UV source (UV fluorescence tube) centered on a wavelength of 308 nm. A direct comparison with the commercially available semiconductor-based UV sensor proves the UVOFS of this investigation shows superior performance in terms of accuracy, long-term reliability, response time and linearity.

The use of optical fiber probe in two-phase flow measurements is very frequently encountered, especially in the applications of chemical engineering and petroleum industries. In this work, the influence of bubble piercing signals caused by bubble deformation is studied experimentally using a laboratory-prepared wedge-shaped fiber probe in a lab-scale gas–liquid flow generator. A three-dimensional simulation model is established to study the influence of bubble deformation on the piercing signals. A theoretical analysis of the characteristics of the pre-signal influenced by the bubble deformations is undertaken for a wide range of different modeled bubble shapes. Combining the experimental and simulation results, a promising analytical method to estimate the bubble shapes by analyzing the characteristics of pre-signals is proposed. The results of this investigation demonstrate that it is possible to estimate the bubble shapes before the fiber probe contacts the bubble surface. The method developed in this investigation is therefore highly promising for reducing errors caused by deformation during the probe piercing process.

A laboratory-prepared wedge-shaped fiber probe using step-index multimode plastic optical fiber was described and tested in a lab-scale gas–liquid flow generator. A three-dimensional model was established in order to fully simulate the process of bubble piercing by the optical fiber probe. A theoretical analysis of the luminous intensity distribution of the light transmission in the process of bubble piercing was undertaken under conditions of different relative positions between the fiber probe and the bubble axis. Using this analytical method, it was possible to accurately define the range of the central region of the bubble where the presignal appeared.

A conical tip–shaped plastic optical fiber sensor for gas-liquid flow measurement is described. Experimental results show that a distinctive spike signal occurs before the output signal when using a conventional conical fiber probe, whereas this spike signal was greatly suppressed when a cleaved probe is used. A full simulation is implemented based on a three-dimensional ray-tracing method providing a means of comparison with theoretical analysis. The results show that an appropriately cleaved tip provides a promising method of enhancing the bubble measurement signal-to-noise ratio.