In vibration tests, the behavior of the structure depends on its mechanical boundary conditions, which are represented in physical tests by connecting elements with mechanical properties. Adjustable impedance elements are machine elements fulfilling the task of an adjustable connection on a vibration test bench and therefore represent a variety of properties. Their mechanical properties must be known over wider ranges than comparable compliant structures tested in the literature. This paper is dedicated to vibration testing of the adjustable impedance elements themselves, taking the influences of fixtures and measuring devices of the test bench into account. Different approaches for measuring the frequency response functions are applied to freely vibrating masses at a hydraulic and an electrodynamic test bench. Mass cancellation and the frequency-dependent measurement systems function have shown their usefulness in characterizing the biodynamic response of hand–arm models before. This measurement method is extended to be transferable to machine elements to obtain reliable results under a wider range of test conditions. The necessity for dynamically calibrated measurement of the frequency response functions is demonstrated for different free vibration masses and for two compliant elements on two different test benches to provide results over a wide range of test conditions.
1 October 2018 in Composites Science and Technology
This publication addresses the development of a compact, adjustable hydraulic damper that meets the requirements for vibration testing. Dampers from the literature do not meet all the requirements, such as compact design, vibration resistance, high strength, broadly adjustable and dominantly symmetrical damping, and modularity. Additive manufacturing (AM) enables the design of integral and compact systems that can compensate for several disadvantages of known damping systems. Three stages of development are presented, from a proof of concept to a prototype manufactured by Stereolithography (SLA) as Vat Photopolymerization (VPP-UVL/P) to a ready-to-use hydraulic damper manufactured by Selective Laser Melting (SLM) as Laser Powder Bed Fusion (PBF-LB/M). The final additively manufactured damper is much more compact due to its geometric freedom in the design phase and requires a much smaller number of components. The damper has been tested over a wide range of operating conditions and has proven its reliable damping performance even under high loads. This performance makes it suitable for many other systems subject to vibration.
17 February 2025 in Journal of Low Frequency Noise, Vibration and Active Control
This paper presents the vibration reduction of lightweight components by adjusting the mechanical properties of their boundary conditions in vibration test rigs. The variable boundary conditions are achieved by adjustable impedance elements, which are mechanical elements that can change their stiffness and damping behavior separately and are designed for use in vibration testing. A new generation of an adjustable impedance element is presented in this publication and its use in a large component test environment. The influence of the adjustable mechanical properties of the interfaces on an aircraft partition is shown. A holistic finite element model is presented to predict the interactions between the adjustable interfaces and the test object. A vibration reduction of about 65% compared to current rigidly designed joints is achieved. The influence of vibration on the partition is investigated experimentally for different stiffness and damping ranges and the corresponding simulation model is validated.