Aquacultures are a sector facing a huge development: farmers usually applying antibiotics to treat and/or prevent diseases. Consequently, effluents from aquaculture represent a source of antibiotics for receiving waters, where they pose a potential threat due to antimicrobial resistance (AMR) induction. This has recently become a major concern and it is expectable that regulations on antibiotics’ discharge will be established in the near future. Therefore, it is urgent to develop treatments for their removal from wastewater. Among the different possibilities, photodegradation under solar radiation may be a sustainable option. Thus, this review aims at providing a survey on photolysis and photocatalysis in view of their application for the degradation of antibiotics from aquaculture wastewater. Experimental facts, factors affecting antibiotics’ removal and employed photocatalysts were hereby addressed. Moreover, gaps in this research area, as well as future challenges, were identified.
Novel photocatalysts were synthesized through the association of carbon quantum dots (CQDs) with commercial (P25) titanium dioxide (TiO2) by sonication. The resulting TiO2/CQDs composite was then incorporated into the polyamide 66 (PA66) biopolymer nanofibers using the electrospinning technique, considering a composite nanoparticles-to-polymer ratio of 1:2 in the electrospinning precursor solution. The produced nanofibers presented suitable morphology and were tested for the photocatalytic degradation under simulated solar radiation of 10 mg L−1 of amoxicillin (AMX) and sulfadiazine (SDZ), in phosphate buffer solution (pH 8.06) and river water, using 1.5 g L−1 of photocatalyst. The presence of the photocatalyst increased the removal of AMX in phosphate buffer solution by 30 times, reducing the AMX degradation half-life time from 62 ± 1 h (without catalyst) to 1.98 ± 0.06 h. Moreover, SDZ degradation half-life time in phosphate buffer solution was reduced from 5.4 ± 0.1 h (without catalyst) to 1.87 ± 0.05 h in the presence of the photocatalyst. Furthermore, the PA66/TiO2/CQDs were also efficient in river water samples and maintained their performance in at least three cycles of SDZ photodegradation in river water. The presented results evidence that the produced photocatalyst can be a promising and sustainable solution for antibiotics’ efficient removal from water.
In this work, carbon dots (CD) were synthesized and coupled to titanium dioxide (TiO2) to improve the photodegradation of antibiotics in aquaculture effluents under solar irradiation. Oxolinic acid (OXA) and sulfadiazine (SDZ), which are widely used in aquaculture, were used as target antibiotics. To prepare nanocomposites of CD containing TiO2, two modes were used: in-situ (CD@TiO2) and ex-situ (CD/TiO2). For CD synthesis, citric acid and glycerol were used, while for TiO2 synthesis, titanium butoxide was the precursor. In ultrapure water (UW), CD@TiO2 and CD/TiO2 showed the largest photocatalytic effect for SDZ and OXA, respectively. Compared with their absence, the presence of CD@TiO2 increased the photodegradation of SDZ from 23 to 97% (after 4 h irradiation), whereas CD/TiO2 increased the OXA photodegradation from 22 to 59% (after 1 h irradiation). Meanwhile, in synthetic sea salts (SSS, 30‰, simulating marine aquaculture effluents), CD@TiO2 allowed for the reduction of SDZ’s half-life time (t1/2) from 14.5 ± 0.7 h (in absence of photocatalyst) to 0.38 ± 0.04 h. Concerning OXA in SSS, the t1/2 remained the same either in the absence of a photocatalyst or in the presence of CD/TiO2 (3.5 ± 0.3 h and 3.9 ± 0.4 h, respectively). Overall, this study provided novel perspectives on the use of eco-friendly CD-TiO2 nanocomposites for the removal of antibiotics from aquaculture effluents using solar radiation.
Novel photocatalysts were synthesized through the association of carbon quantum dots (CQDs) with commercial (P25) titanium dioxide (TiO2) by sonication. The resulting TiO2/CQDs compo-site was then incorporated into the polyamide 66 (PA66) biopolymer nanofibers using the elec-trospinning technique, considering a composite nanoparticles-to-polymer ratio of 1:2 in the elec-trospinning precursor solution. The produced nanofibers presented suitable morphology and were tested for the photocatalytic degradation under simulated solar radiation of 10 mg/L of amoxicillin (AMX) and sulfadiazine (SDZ), in phosphate buffer solution (pH 8.06) and river wa-ter, using 1.5 g/L of photocatalyst. The presence of the photocatalyst increased the removal of AMX in phosphate buffer solution by 30 times, reducing the AMX degradation half-life time from 62 ± 1 h (without catalyst) to 1.98 ± 0.06 h. Moreover, SDZ degradation half-life time in phosphate buffer solution was reduced from 5.4 ± 0.1 h (without catalyst) to 1.87 ± 0.05 h in the presence of the photocatalyst. Furthermore, the PA66/TiO2/CQDs were also efficient in river wa-ter samples, and maintained their performance in at least three cycles of SDZ photodegradation in river water. The presented results evidence that the produced photocatalyst can be a promis-ing and sustainable solution for antibiotics’ efficient removal from water.