Bakari M. M. Mwinyiwiwa

Prof. Bakari M. M. Mwinyiwiwa


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 September 2021 in Energies
Verified
Journal Article
Open access
PDF file
MJMwaka Juma
Mwaka Juma
BMBakari M. M. Mwinyiwiwa
Bakari M. M. Mwinyiwiwa
CMConsalva J. Msigwa
Consalva J. Msigwa
AMAviti Thadei Mushi
Aviti Thadei Mushi
This paper presents microgrid-distributed energy resources (DERs) for a rural standalone system. It is made up of a solar photovoltaic (solar PV) system, battery energy storage system (BESS), and a wind turbine coupled to a permanent magnet synchronous generator (WT-PMSG). The DERs are controlled by maximum power point tracking (MPPT)-based proportional integral (PI) controllers for both maximum power tracking and error feedback compensation. The MPPT uses the perturb and observe (P&O) algorithm for tracking the maximum power point of the DERs. The PI gains are tuned using the Ziegler–Nichols method. The developed system was built and simulated in MATLAB/Simulink under two conditions—constant load, and step-load changes. The controllers enabled the BESS to charge even during conditions of varying load and other environmental factors such as change of irradiance and wind speed. The reference was tracked extremely well by the output voltage of the DC microgrid. This is useful research for electrifying the rural islanded areas which are too far from the grid.

2 October 2024 in Tanzania Journal of Science
Verified
Journal Article
Open access
PDF file
SSStampinus M. Stephano
Stampinus M. Stephano
JJJackson John Justo
Jackson John Justo
BMBakari M. M. Mwinyiwiwa
Bakari M. M. Mwinyiwiwa
A combined Single-Ended Primary-Inductor Converter (SEPIC) and Cuk DC-DC converter that provides a bipolar outputs voltage at the DC bus is widely used in applications especially solar photovoltaic (SPV) system. Maintaining constant output voltages at the DC bus under variable loads and input voltage from SPV is of great interest to many researchers. This paper presents a 400 W mathematical model of a combined SEPIC and Cuk DC-DC converter through state space averaging (SSA) in a continuous conduction mode (CCM). A nested voltage and current control loops are used to regulate voltage and increase the performance of the converter. These controls use Proportional-Integral (PI) controllers to track the desired input reference signal and eliminate any disturbance from the load. The entire model with its control algorithm was modelled in MATLAB/Simulink environment and validation results to evaluate its performance are presented. The controller was able to maintain required bus voltage of 24 V DC and -/+12 V at the output DC bus. DC bus voltage regulation was tested at varying input voltages and varying loads connected at the output, where, in all those scenarios, the converter could regulate its output voltage to required value.