Alexey N. Sokolovskiy

Dr. Alexey N. Sokolovskiy

Air Force Research Laboratory (Space Vehicles Directorate), Albuquerque, NM, USA

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 September 2020 in Journal of Geophysical Research: Space Physics
Verified
Journal Article
Open access
PDF file
ASAnatoly V. Streltsov
Anatoly V. Streltsov
MBMiles T. Bengtson
Miles T. Bengtson
This paper presents results from a modeling study of localized packages of very low frequency (VLF) whistler mode waves observed by the NASA Van Allen Probes (also known as the Radiation Belt Storm Probes [RBSP]) satellites in the equatorial magnetosphere. The waves are detected inside enhancements of the plasma density, which we interpret as high‐density ducts. The quality of the ducting depends on the wave and duct parameters. The goal of this study is to investigate relations between these parameters. This study is based on the analysis and simulations of the electron MHD model. The results demonstrate that (1) the high‐density ducts with the magnitudes and perpendicular sizes observed by the RBSP satellites can trap VLF waves with the observed frequency and guide them over a significant distance with little attenuation. (2) It is possible to identify the range of magnitudes of the parallel and perpendicular wavelengths using the information about frequency of the waves and parameters of the duct.

2 May 2019 in IEEE Transactions on Plasma Science
Verified
Journal Article
Closed access
MBMiles Bengtson
Miles Bengtson
JHJoseph Hughes
Joseph Hughes
HSHanspeter Schaub
Hanspeter Schaub
A method is investigated to use secondary electrons to touchlessly sense the electrostatic potential of an object in geosynchronous orbit or deep space. This method involves a positively charged servicing craft, which directs a high-energy electron beam at the object of interest such that low-energy secondary electrons are emitted from the surface. The low-energy electrons emitted by the target are accelerated toward the servicing craft and arrive with an energy equal to the potential difference between the two crafts. The servicing craft measures the electron energy spectrum and, knowing its own potential, then infers the potential of the target. Depending on the application, photoelectrons could similarly be used to infer the target potential without the need for an active electron beam. Though it is possible to measure potential by directly contacting a surface, remote measurement offers significant advantages and supports missions which must operate in close proximity without making physical contact. Several missions have been proposed that use interactions between charged objects to create useful forces and torques, including electrostatic detumbling and reorbiting of debris, Coulomb formations, and virtual structures. Remote measurement of potential would benefit these missions by enabling feedback control of the active charging. Other applications include mitigation of arcing during rendezvous, docking, and proximity operations for future servicing or salvaging missions.

8 November 2022 in Surface and Coatings Technology
Verified
Journal Article
Closed access
Alexey N. SokolovskiyAlexey N. Sokolovskiy
Alexey N. Sokolovskiy
EPElena Plis
Elena Plis
RHRyan Hoffmann
Ryan Hoffmann
MBMiles Bengtson
Miles Bengtson
DFDale Ferguson
Dale Ferguson

1 May 2016 in Journal of Spacecraft and Rockets
Verified
Journal Article
Closed access
DFDale Ferguson
Dale Ferguson
PCPeter Crabtree
Peter Crabtree
SWStephen White
Stephen White
BVBoris Vayner
Boris Vayner
It is well known that many GPS satellites have experienced power degradation in excess of what would be expected from radiation damage on their solar arrays. Originally, contamination was suspected, based on the time behavior and rate of degradation seen. Calorimeters were included on some satellites, and a temperature rise commensurate with the power loss was detected, but subsequent efforts to eliminate line-of-sight paths from the contamination sources were unfruitful in reducing the power degradation. The hypothesis put forward here is that the contamination is the result of solar array arcing over a GPS lifetime. In this paper, we examine this hypothesis, using known characteristics of space solar array arcs, to place limits on the arc rate that would be sufficient to produce the contamination-induced power losses seen on GPS satellites to date. Comparisons with United States Nuclear Detonation Detection System signals on GPS satellites are consistent with at least some of the United States Nuclear Detonation Detection System events being solar array arcs. If the hypothesis can be confirmed, simple measures to prevent arcing on GPS arrays can lower the contamination rate and either increase end-of-life power or allow reduced beginning-of-life power.

1 April 2020 in Space Weather
Verified
Journal Article
Open access
PDF file
KWK. T. Wilson
K. T. Wilson
MBM. T. Bengtson
M. T. Bengtson
HSH. Schaub
H. Schaub
Remote surface potential determination for nearby objects in space is an enabling technology for a range of space mission concepts, from improved rendezvous capabilities to touchless debris remediation with the electrostatic tractor concept. One concept is to use a nearby servicing spacecraft which fires electrons at the target. These electrons generate bremsstrahlung X‐rays, and the resultant X‐ray spectrum can be used to determine the landing energy of the electrons. By knowing the initial energy of the electrons, such as those emitted from an electron gun, the relative potential of the target can be inferred. The use of electron‐induced X‐rays to determine the electrostatic potential of a surface has previously been investigated theoretically, but this work demonstrates it experimentally. Accuracy is found to correlate to the angle between the detector and the target, and investigation of this relationship is a topic of future work. The mean error in landing energy is found to be approximately 1%, and the mean error in estimated plate voltage is found to be within the uncertainty of the high voltage power supply. Material determination is successfully demonstrated, using characteristic X‐rays to identify elements that make up less than 0.5% by mass of the target sample. Several possible means of improving landing energy accuracy are discussed.

13 April 2021 in IEEE Transactions on Plasma Science
Verified
Journal Article
Closed access
EPElena Plis
Elena Plis
DEDaniel P. Engelhart
Daniel P. Engelhart
VMVanessa J. Murray
Vanessa J. Murray
ASAlexey N. Sokolovskiy
Alexey N. Sokolovskiy
DBDavid A. Barton
David A. Barton
RHRyan C. Hoffman
Ryan C. Hoffman
The harsh space environment at geosynchronous orbit (GEO) induces differential charging of spacecraft surfaces due to simultaneous fluxes of electrons with a wide distribution of energies onto, into, and through spacecraft surface materials. Thus, satellite surfaces can charge thousands of volts with respect to each other, whereas entire satellites can charge tens of thousands of volts negative relative to their surrounding space plasma. The ensuing electric fields can cause local discharges (arcs) from one part of the spacecraft to another, endangering the normal operation of the satellite. Furthermore, solar cell coverglass contamination induced by the high rate of arcing is sufficient to produce the ~1.5%/year power loss in excess of radiation damage that has been observed on global positioning system (GPS) satellites. This work focuses on evaluation of a GEO space weather effect on material properties caused by irradiating different types of commonly used space solar cell coverglasses (CMX, fused silica, and Corning 0214) with >90-keV electron radiation.