Interference between ultrawideband (UWB) antennas and other narrowband communication systems has spurred growth in designing UWB antennas with notch characteristics and complicated designs consisting of irregular etched slots and larger physical size. This article presents a simplified notched design method for existing UWB antennas exhibiting four frequency-band-rejecting characteristics. The investigation has been conducted by introducing four semicircular U-shaped slot structures based on a theoretical formulation. The formulation is validated with the equivalent LC lumped parameters responsible for yielding the notched frequency. A novel feature of our approach is that the frequency notch can be adjusted to the desired values by changing the radial length based on the value calculated using a derived formula for each semietched U-slot, which is very simple in structure and design. Additionally, by introducing the rectangular notch at the ground plane, the upper passband spectrum is suppressed while maintaining the wide impedance bandwidth of the antenna applicable for next-generation wireless communications, 5G. The measured result shows that the antenna has a wide impedance bandwidth of 149% from 2.9 to 20 GHz, apart from the four-notched frequencies at 3.49, 3.92, 4.57, and 5.23 GHz for a voltage standing wave ratio (VSWR) of <2 rejecting the Worldwide Interoperability for microwave Access (WiMAX) band at (3.38-3.7 GHz), the European C-band at (3.84-4.29 GHz), the Indian national satellite (INSAT) at (4.47-4.92 GHz), and wireless local area networks (WLANs) at (5.09-5.99 GHz). Measured and simulated experimental results reveal that the antenna exhibits nearly an omnidirectional pattern in the passband, low gain at the stopband, and good radiation efficiency within a frequency range. The LC equivalent notched frequency has been proposed by analyzing the L and C equivalent formula, and it has been validated with simulated and measured results. The measurement and simulated results correspond well at the LC equivalent notch band rejecting the existing narrowband systems.

The correlation between the antennas of multiple-input, multiple-output (MIMO) systems in limited spaces and size degrades the performance and capacity by either using complex coupling or decoupling structures. For isolation improvement, this paper presents the simple design of a compact high-isolation ultra-wideband (UWB) MIMO antenna with a circular parasitic element at the back side of the radiating patch, thereby creating the reverse coupling and helping reduce the mutual coupling at the upper part of the frequency bands, and a small rectangular notch at the ground plane to extend the impedance bandwidth of the monopole antenna. This approach eliminates the use of complex coupling or decoupling structures and complex feeding networks. A novel feature of our design is that the MIMO antenna exhibits a very low envelope correlation coefficient (ECC < 0.007) with high diversity gain (DG > 9.99) and wide impedance bandwidth of 139 % from 3.1 to 17.5 GHz applicable for not only UWB application, but also next generation wireless communication, 5G. The high peak gain over the entire UWB and the upper part of the overall frequency band ensure that the antenna can be used in MIMO applications owing to the close agreement between the simulated and measured results.

This paper describes a novel feed system for compact, wideband, high gain six-slot Vivaldi antenna arrays on a single substrate layer using a unique combination of power splitters based on binary T-junction power splitter topology, frequency-independent phase shifter, and a T-branch. The proposed antenna system consists of six Vivaldi antennas, three on the left, and three on the right arm. Each arm connects with T-junction power divider splitter topology, given that the right arm is linked through a frequency-independent phase shifter. Phase shifters ensure that the beam is symmetrical without splitting in a radiating plane so that highly directive radiation patterns occur. The optimal return losses (S-parameters) are well enriched by reforming Vivaldi’s feeding arms and optimizing Vivaldi slots and feeds. A novel feature of our design is that the antenna exhibits the arrangements of a T-junction power splitter with an out-of-phase feeding mechanism in one of the arms, followed by a T-branching feeding to even arrays of proper Vivaldi antenna arrangement contributing high realized gain and front-to-back ratio up to 14.12 dBi and 23.23 dB respectively applicable for not only ultra-wideband (UWB) application, also for sensing and position detecting. The high directivity over the entire UWB frequency band in both higher and lower frequency ranges ensures that the antenna can be used in microwave through-wall imaging along with resolution imaging for ground penetration radar (GPR) applications. The fabricated antenna parameters are in close agreement with the simulated and measured results and are deployed for the detection of targets inside the voids of the concrete brick.

This paper proposes a planar wideband microstrip feedline to a slot-line-based patch antenna for high-frequency pattern diversity applications. The antenna consists of two adjacent rectangular patches separated by the ground slots, with a directive patch slot along the edge of the substrate. A compact common feedline-to-slot configuration is used to miniaturize the antenna. The antenna is designed in stages, starting with an in-phase feedline, followed by a slot line structure, with two radiating patches on top and a director on the side. This creates radiation diversity with directive radiation patterns. The antenna was fabricated and analyzed inside a far-field anechoic chamber. The experimental results validate the return loss, gain, and radiation performance. The measured results of the antenna within a frequency range of 8.5 to 11 GHz show good agreement with the simulation. The antenna has a maximum gain of 9.2 dBi and has the potential to be beneficial for beam steering and X-band applications due to its low profile, broad bandwidth, high gain, and good directivity.

In this paper, double slot podal and antipodal ultra-wideband (UWB) microstrip antennas for a fluid property measurement system are proposed. Among different feeding techniques, out of phase uni-planner power divider approach is used. The performance verification of the proposed antenna is explained, along with a performance comparison of the antenna bandwidth, feeding, and the realized gain. The suggested podal antenna has an impedance bandwidth from 2.4 to 15.4 GHz, with a maximum gain of 11.3 dBi in the 12 GHz region while the antipodal antenna has a 2.8 GHz to 16 GHz impedance bandwidth, with a maximum gain of 10.4 dBi in the 10 GHz region. Within the intended band, the radiation pattern had an excellent directivity characteristic. The implementation of the proposed antenna is calibrated by measuring the propagated signals response via various liquid specimens using UWB radar, which might be applied for fluid sensing and prediction purposes. The proposed antenna was connected to an NVA-R661 module of Xethru Inc. for measuring the sample delay and peak-to-peak amplitude of the received signals passing through specimens. The measured parameters at a different radar frequency range of transmission are applied by drawing the fluid viscous analogy based on Poiseuille’s law hypothesis, showing clear differentiation between the test specimens.

In this paper, a horn-shaped strip antenna exponentially tapered carved on a multilayer dielectric substrate for an indoor body position tracking system is proposed. The performance of the proposed antenna was verified by testing it as a tracking state of an indoor resting body position. Among different feeding techniques, the uniplanar T-junction power divider approach is used. The performance verification of the proposed antenna is explained through its compact size and 3D shape, along with a performance comparison of the return loss radiation pattern and the realized gain. The suggested antenna has an 88.88% fractional bandwidth and a return loss between 6 and 15.6 GHz, with a maximum gain of 9.46 dBi in the 9.5 GHz region. Within the intended band, the radiation pattern had an excellent directivity characteristics. The proposed antenna was connected to an NVA-R661 module of Xethru Inc. for sleeping body position tracking. The performance of the antenna is measured through microwave imagining of the state of the resting body in various sleeping positions on the bed using a Recurrent Neural Network (RNN). The predicted outcomes clearly define the antenna’s performance and could be used for sensing and prediction purposes.