This study aims to critically assess different micromechanical analysis models applied to carbon-fiber-reinforced plastic (CFRP) composites, employing micromechanics-based homogenization to accurately predict their effective properties. The paper begins with the simplest Voigt and Reuss models and progresses to more sophisticated micromechanics-based models, including the Mori–Tanaka and Method of Cells (MOC) models. It provides a critical review of the areas in which these micromechanics-based models are effective and analyses of their limitations. The numerical analysis results were confirmed through finite element simulations of the periodic representative volume element (RVE). Furthermore, the effective properties predicted by these micromechanics-based models were validated via experiments conducted on IM7/5320-1 composite material with a fiber volume fraction of 0.62.

This study describes the numerical simulation results of aluminum/carbon-fiber-reinforced plastic (CFRP) hybrid joint parts using the explicit finite-element solver LS-DYNA, with a focus on capturing the failure behavior of composite laminates as well as the adhesive capacity of the aluminum–composite interface. In this study, two types of adhesive modeling techniques were investigated: a tiebreak contact condition and a cohesive zone model. Adhesive modeling techniques have been adopted as a widely commercialized model of structural adhesives to simulate adhesive failure based on fracture mechanics. CFRP was studied with numerical simulations utilizing LS-DYNA MAT54 to analyze the crash capability of aluminum/CFRP. To evaluate the simulation model, the results were compared with the force–displacement curve from numerical analysis and experimental results. A parametric study was conducted to evaluate the effect of different fracture toughness values used by designers to predict crash capability and adhesive failure of aluminum/CFRP parts.

A novel simple design of birdcage type RF receiver coil for using in the ¹H NMR (Nuclear Magnetic Resonance) imaging system operating at 1.5 T and 3.0 T has been demonstrated. The RF coil is a band pass type coil composed of legs and end rings and both legs and end rings are made of epoxy-etched copper strips on a single flexible circuit board. The important feature of the coil with multiple resonance frequency is the use of multiple capacitors in each leg of the coil. The coil is capable to resonate at 64 MHz (1.5 T) and 127 MHz (3.0 T) simultaneously. We have analyzed the performance of the coil through simulations and experimental measurements.