Gasoline vehicle exhaust is an important contributor to secondary organic aerosol (SOA) formation in urban atmosphere. Fuel composition has a potentially considerable impact on gasoline SOA production, but the link between fuel components and SOA production is still poorly understood. Here, we present chamber experiments to investigate the impacts of gasoline aromatic content on SOA production through chamber oxidation approach. A significant amplification factor of 3–6 for SOA productions from gasoline exhausts is observed as gasoline aromatic content rose from 29 to 37 %. Considerably higher emission of aromatic volatile organic compounds (VOCs) using high-aromatic fuel plays an essential role in the enhancement of SOA production, while semi-volatile organic compounds (e.g., gas-phase PAHs) may also contribute to the higher SOA production. Our findings indicate that gasoline aromatics significantly influence ambient PM_2. 5 concentration in urban areas and emphasize that more stringent regulation of gasoline aromatic content will lead to considerable benefits for urban air quality.

Liquid ammonia is an ideal zero-carbon fuel for internal combustion engines. High-pressure injection is a key technology in organizing ammonia combustion. Characteristics of high-pressure liquid ammonia injection is lack of research. Spray behaviors are likely to change when a high-pressure diesel injector uses liquid ammonia as its fuel. This study uses high-speed imaging with a DBI method to investigate the liquid penetration, width, and spray tip velocity of high-pressure liquid ammonia injection up to 100 MPa. Non-flash and flash boiling conditions were included in the experimental conditions. Simulation was also used to evaluate the results. In non-flash boiling conditions, the Hiroyasu model provided better accuracy than the Siebers model. In flash boiling conditions, a phenomenon was found that liquid penetration and spray tip velocity were strongly suppressed in the initial stage of the injection process, this being the “spray resistance phenomenon”. The “spray resistance phenomenon” was observed when ambient pressure was below 0.7 MPa during 0–0.05 ms ASOI and was highly related to the superheated degree. The shape of near-nozzle sprays abruptly changed at 0.05 ms ASOI, indicating that strong cavitation inside the nozzle caused by needle lift effects is the key reason for the “spray resistance phenomenon”.

Today, the problem of energy shortage and climate change has urgently motivated the development of research engaged in improving the fuel efficiency of internal combustion engines (ICEs). Although many constructive alternatives—including battery electric vehicles (BEVs) and low-carbon fuels such as biofuels or hydrogen—are being put forward, they are starting from a very low base, and still face significant barriers. Nevertheless, 85–90% of transport energy is still expected to come from combustion engines powered by conventional liquid fuels even by 2040. Therefore, intensive passion for the improvement of engine thermal efficiency and decreasing energy loss has driven the development of reliable approaches and modelling to fully understand the underlying mechanisms. In this paper, literature surveys are presented that investigate the relative advantages of technologies mainly focused on minimizing energy loss in engine assemblies, including pistons and rings, bearings and valves, water and oil pumps, and cooling systems. Implementations of energy loss reduction concepts in advanced engines are also evaluated against expectations of meeting greenhouse gas (GHG) emissions compliance in the years to come.