Coconut husks with the shells attached are potential bioenergy resources for fuel-constrained communities in Ghana. In spite of their energy potential, coconut husks and shells are thrown away or burned raw resulting in poor sanitation and environmental pollution. This study focuses on quantifying the waste proportions, calorific values and pollutant emissions from the burning of raw uncharred and charred coconut wastes in Ghana. Fifty fresh coconuts were randomly sampled, fresh coconut waste samples were sun-dried up to 18 days, and a top-lit updraft biochar unit was used to produce biochar for the study. The heat contents of the coconut waste samples and emissions were determined. From the results, 62–65% of the whole coconut fruit can be generated as wastes. The calorific value of charred coconut wastes was 42% higher than the uncharred coconut wastes. PM_2.5 and CO emissions were higher than the WHO 24 h air quality guidelines (AQG) value at 25 °C, 1 atmosphere, but the CO concentrations met the WHO standards based on exposure time of 15 min to 8 h. Thus, to effectively utilise coconut wastes as sustainable bioresource-based fuel in Ghana, there is the need to switch from open burning to biocharing in a controlled system to maximise the calorific value and minimise smoke emissions.

Small wind turbine power generation systems have the potential to meet the electricity demand of the residential sector in developing countries. However, due to their exposure to low Reynolds number (Re) flow conditions and associated problems, specific airfoils are required for the design of their blades. In this research, XFOIL was used to develop and test three high performance airfoils (EYO7-8, EYO8-8, and EYO9-8) for small wind turbine application. The airfoils were subsequently used in conjunction with Blade Element Momentum Theory to develop and test 3-bladed 6 m diameter wind turbine rotors. The aerodynamic performance parameters of the airfoils tested were lift, drag, lift-to-drag ratio, and stall angle. At Re=300,000, EYO7-8, EYO8-8, and EYO9-8 had maximum lift-to-drag ratios of 134, 131, and 127, respectively, and maximum lift coefficients of 1.77, 1.81, and 1.81, respectively. The stall angles were 12° for EYO7-8, 14° for EYO8-8, and 15° for EYO9-8. Together, the new airfoils compared favourably with other existing low Re airfoils and are suitable for the design of small wind turbine blades. Analysis of the results showed that the performance improvement of the EYO-Series airfoils is as a result of the design optimization that employed an optimal thickness-to-camber ratio (t/c) in the range of 0.85–1.50. Preliminary wind turbine rotor analysis also showed that the EYO7-8, EYO8-8, and EYO9-8 rotors had maximum power coefficients of 0.371, 0.366, and 0.358, respectively.

Over 600 million people living in sub-Saharan Africa do not have access to electricity. Modern healthcare services, including vaccine refrigeration, which require electricity are therefore lacking in such energy-deprived communities. In this work, analysis has been conducted on how electricity access can help improve healthcare service delivery and rural development, with a case study on 3 different off-grid solar photovoltaic (PV) systems in community-based health planning and services (CHPS) in Ghana. Analysis from this study showed that for the 3.0 kWp solar PV systems installed at the various sites, the in-house electricity consumptions are between 4.30 and 7.58 kWh per day. It was found out that excess electricity generation of 148–304 kWh per month is available and can be used to provide other economic services including phone charging, torchlight battery charging, and small-sized cold storage services to generate income for the maintenance of the systems, which is critical for sustainability of solar PV installations in rural poor communities. The study results also showed that electrified health facilities which are able to provide basic healthcare services have potential impact on community health outcomes and rural development. Assessment conducted at the CHPS compounds revealed that, generally, there is improvement in healthcare service delivery resulting in time savings of 15-43 hours per month for the inhabitants which can potentially be used for productive work. The time savings were more significant in females and children than in males. In many rural agro-based communities in developing countries, female and children are usually the workforce engaged in various farming activities. This paper concludes that access to electricity in CHPS compounds helps to improve community health outcomes and increases time availability for women to engage in productive work that can potentially result in significant socioeconomic activities and rural development.