Global demand for minimally processed fruits and vegetables is increasing due to the tendency to acquire a healthy lifestyle. Losses of these foods during the chain supply reach as much as 30%; reducing them represents a challenge for the industry and scientific sectors. The use of edible packaging based on biopolymers is an alternative to mitigate the negative impact of conventional films and coatings on environmental and human health. Moreover, it has been demonstrated that natural coatings added with functional compounds reduce the post-harvest losses of fruits and vegetables without altering their sensorial and nutritive properties. Furthermore, the enhancement of their mechanical, structural, and barrier properties can be achieved through mixing two or more biopolymers to form composite coatings and adding plasticizers and/or cross-linking agents. This review shows the latest updates, tendencies, and challenges in the food industry to develop eco-friendly food packaging from diverse natural sources, added with bioactive compounds, and their effect on perishable foods. Moreover, the methods used in the food industry and the new techniques used to coat foods such as electrospinning and electrospraying are also discussed. Finally, the tendency and challenges in the development of edible films and coatings for fresh foods are reviewed.
The aim of this study was evaluated the biofilm formation by Staphylococcus aureus 4E and Salmonella spp. under mono and dual-species biofilms, onto stainless steel 316 (SS) and polypropylene B (PP), and their sensitivity to cetrimonium bromide, peracetic acid and sodium hypochlorite. The biofilms were developed by immersion of the surfaces in TSB by 10 d at 37°C. The results showed that in monospecies biofilms the type of surface not affected the cellular density (p>0.05). However, in dual-species biofilms on PP the adhesion of Salmonella spp. was favored, 7.61±0.13Log10CFU/cm2, compared with monospecies biofilms onto the same surface, 5.91±0.44Log10CFU/cm2 (p<0.05). The mono and dual-species biofilms were subjected to disinfection treatments; and the most effective disinfectant was peracetic acid (3500ppm), reducing by more than 5Log10CFU/cm2, while the least effective was cetrimonium bromide. In addition, S. aureus 4E and Salmonella spp. were more resistant to the disinfectants in mono than in dual-species biofilms (p<0.05). Therefore, the interspecies interactions between S. aureus 4E and Salmonella spp. had a negative effect on the antimicrobial resistance of each microorganism, compared with the monospecies biofilms.
Staphylococcus aureus is an important food-borne pathogen able to form biofilms. This pathogen is responsible for outbreaks of food-borne illnesses associated with the consumption of milk and dairy products. The aim of this study was to evaluate the biofilm-forming ability of S. aureus isolates, recovered from food contact surfaces in the dairy industry of Jalisco, Mexico. A total of 84 S. aureus strains were evaluated. The isolates were characterized phenotypically by culture on Congo red agar plates. The ability of the strains to form biofilms was investigated in 96-well flat-bottomed microtiter polystyrene plates. Stainless-steel coupons were used as an experimental surface. Biofilm formation was observed, using epifluorescence microscopy and scanning electron microscopy. Detection of the icaADBC genes in S. aureus was performed by the PCR technique. A total of 52.3% (44/84) of the S. aureus strains contained the icaADBC gene that synthesizes polysaccharide intercellular adhesion (PIA) molecules. On Congo red agar, 75% (63/84) of the S. aureus isolates were biofilm producers, 16.6% (14/84) were non-biofilm formers, and 8.3% (7/84) showed a noncharacteristic phenotype. The biofilm production of the S. aureus strains SA-4E, SA-9, SA-13, and SA-19 on stainless-steel coupons was investigated at 25°C for 8 days, and the detected cell population density was approximately 7.15–7.82 log CFU cm−2. In addition to the ability of biofilm production, it is important to highlight that these strains are potential enterotoxin producers as se genes have been previously detected in their genomes. A part of the ability of biofilm production and the determination of the presence of virulence determinants in the genome of S. aureus can contribute to the pathogenicity of strains. Therefore, vigilant food safety practices need to be implemented in the dairy industries regarding FCS to prevent food-borne infections and intoxications due to S. aureus contamination.
1 August 2019 in International Journal of Food Microbiology