Observations of the anomalous Hall effect in RuO2 and MnTe have demonstrated unconventional time-reversal symmetry breaking in the electronic structure of a recently identified new class of compensated collinear magnets, dubbed altermagnets. While in MnTe, the unconventional anomalous Hall signal accompanied by a vanishing magnetization is observable at remanence, the anomalous Hall effect in RuO2 is excluded by symmetry for the Néel vector pointing along the zero-field [001] easy-axis. Guided by a symmetry analysis and ab initio calculations, a field-induced reorientation of the Néel vector from the easy-axis toward the [110] hard-axis was used to demonstrate the anomalous Hall signal in this altermagnet. We confirm the existence of an anomalous Hall effect in our RuO2 thin-film samples, whose set of magnetic and magneto-transport characteristics is consistent with the earlier report. By performing our measurements at extreme magnetic fields up to 68 T, we reach saturation of the anomalous Hall signal at a field Hc ≃ 55 T that was inaccessible in earlier studies but is consistent with the expected Néel-vector reorientation field.
We present a systematic growth study of epitaxial RuO2(110) and IrO2(110) on TiO2(110) substrates by pulsed laser deposition. We describe the main challenges encountered in the growth process, such as a deteriorating material flux due to laser-induced target metallization or the delicate balance of under- vs over-oxidation of the “stubborn” Ru and Ir metals. We identify growth temperatures and oxygen partial pressures of 700 K, 1 × 10−3 mbar for RuO2 and 770 K, 5 × 10−4 mbar for IrO2 to optimally balance between metal oxidation and particle mobility during nucleation. In contrast to IrO2, RuO2 exhibits layer-by-layer growth up to 5 unit cells if grown at high deposition rates. At low deposition rates, the large lattice mismatch between film and substrate fosters initial 3D island growth and cluster formation. In analogy to reports for RuO2 based on physical vapor deposition [He et al., J. Phys. Chem. C 119, 2692 (2015)], we find these islands to eventually merge and grow to continue in a step flow mode, resulting in highly crystalline, flat, stoichiometric films of RuO2(110) (up to 30 nm thickness) and IrO2(110) (up to 13 nm thickness) with well-defined line defects.
13 February 2023 in The Journal of Physical Chemistry C
Ironsand is an abundant and inexpensive magnetic mineral resource. However, the magnetic properties of unprocessed ironsand are often inadequate for any practical applications. In this work, the applicability of ironsand for use as a component in a soft magnetic composite for large-scale inductive power transfer applications was investigated. After magnetic separation, the chemical, structural and magnetic properties of ironsand sourced from different locations were compared. Differences observed in the DC magnetic properties were consistent with changes in the chemical compositions obtained from X-ray Absorption Near-Edge Spectroscopy (XANES), which suggests varying the titanohematite to titanomagnetite content. Increased content in titanomagnetite and magnetic permeability correlated well with the total Fe content in the materials. The best-performing ironsand with the highest permeability and lowest core losses was used alongside Mn,Zn-Ferrite particles (ranging from ∼100 m to 2 mm) to fabricate toroid cores with varying magnetic material loading. It was shown that ironsand can be used to replace up to 15 wt.% of the magnetic materials with minimal impact on the composite magnetic performance, thus reducing the cost. Ironsand was also used as a supporting material in a single-rail wireless power transfer system, effectively increasing the power transfer, demonstrating potential applications to reduce flux leakage.