Jawad Rabbi

Mr. Jawad Rabbi

orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 September 2023 in Energy Storage
Verified
Journal Article
Closed access
MAMuhammad Asif
Muhammad Asif
JRJawad Rabbi
Jawad Rabbi
WBWajeeha Bibi
Wajeeha Bibi

22 July 2021 in Energy Storage
Verified
Journal Article
Open access
PDF file
JRJawad Rabbi
Jawad Rabbi
MAMuhammad Asif
Muhammad Asif
WBWajeeha Bibi
Wajeeha Bibi
This study manifests the improvement in the charging and discharging time of the encapsulated PCM arranged in packed bed thermal energy storage. The combined effect of the aspect ratio (ratio of height to diameter of the packed bed) and cascaded configurations of phase change materials (PCMs) integrated with the solar water heating system is analyzed numerically. The mathematical model is validated by the experimental study available in the literature. Initially, an optimal aspect ratio of the packed bed is predicted for charging/discharging. And then, PCMs are arranged in different layers in the packed bed based on the optimal aspect ratio to analyze the combined effect of PCM configurations and optimal aspect ratio. The charging and discharging time were decreased with an increasing aspect ratio to 2.5. Afterward, an increased aspect ratio showed a trivial change in the charging and discharging time of latent heat thermal energy storage (LHTES). Furthermore, at an optimal aspect ratio of 2.5, PCMs were arranged in the packed bed with both axial (parallel) and combined axial‐radial layers (parallel and series) to see the impact of the cascaded configuration. Charging and discharging time of combined axial‐radial layers configuration was respectively found to be 17.21% and 18.5%, less than charging time without layers.

20 December 2021 in Engineering Proceedings
Verified
Conference Paper
Open access
PDF file
JRJawad Rabbi
Jawad Rabbi
MAMuhammad Asif
Muhammad Asif
WBWajeeha Bibi
Wajeeha Bibi
This research focuses on the enhancement of the heat transfer in the concentric tube type of thermal energy storage (TES). The collective influence of the aspect ratio and number of fins is investigated. First, an optimal aspect ratio of the concentric tube TES is found. Additionally, then, the optimal number of fins is found. This combined optimal configuration of TES is then compared with concentric tube TES without. Liquid fraction of the combined optimal configuration was increased by 100% for case of charging as compared to TES without fins.

12 January 2022 in Engineering Proceedings
Verified
Conference Paper
Open access
PDF file
WBWajeeha Bibi
Wajeeha Bibi
MAMuhammad Asif
Muhammad Asif
JRJawad Rabbi
Jawad Rabbi
VMD is one of the desalination technologies used for drinking water purification because of it higher permeate flux and lower energy consumption, and it uses low grade energy for operation. However, there are some critical problems related to VMD, one of which is membrane fouling. In the present study, the fouling phenomenon in VMD is investigated using constant pressure-blocking filtration laws. The results of constant pressure-blocking filtration law indicated that the permeate flux was initially unaffected by the cake layer, but with the passage of time as the pores began to constrict, a formation of a relatively thick cake layer was observed, which resulted in the decrease of permeate flux.