This paper presents the development and implementation of a consumer Digital Twin (DT) for energy demand prediction under the SENDER (Sustainable Consumer Engagement and Demand Response) project, funded by HORIZON 2020. This project aims to engage consumers in the energy sector with innovative energy service applications to achieve proactive Demand Response (DR) and optimized usage of Renewable Energy Sources (RES). The proposed DT model is designed to digitally represent occupant behaviors and energy consumption patterns using Artificial Neural Networks (ANN), which enable continuous learning by processing real-time and historical data in different pilot sites and seasons. The DT development incorporates the International Energy Agency (IEA)—Energy in Buildings and Communities (EBC) Annex 66 and Drivers-Needs-Actions-Systems (DNAS) framework to standardize occupant behavior modeling. The research methodology consists of the following steps: (i) a mock-up simulation environment for three pilot sites was created, (ii) the DT was trained and calibrated using the artificial data from the previous step, and (iii) the DT model was validated with real data from the Alginet pilot site in Spain. Results showed a strong correlation between DT predictions and mock-up data, with a maximum deviation of ±2%. Finally, a set of selected Key Performance Indicators (KPIs) was defined and categorized in order to evaluate the system’s technical effectiveness.
Although hydrogen plays a crucial role in the EU’s strategy to reduce greenhouse gas emissions, its storage and transport are technically challenging. If ammonia is produced efficiently, it can be a promising hydrogen carrier, especially in decentralized and flexible conditions. The Horizon EU HySTrAm project addresses this problem by developing a small-scale, containerized demonstration plant consisting of (1) a short-term hydrogen storage container using novel ultraporous materials optimized through machine learning, and (2) an ammonia synthesis reactor based on an improved low-pressure Haber–Bosch process. This paper presents an initial version of a Python (v3.9)-based dashboard designed to visualize and optimize the simulation workflow of the ammonia synthesis process. Designed as a baseline for a future online, automated tool, the dashboard allows the comparison of three reactor configurations already defined through simulations and aligned with the upcoming experimental campaign: single tube, two reactors in parallel swing mode and two reactors in series. Pressures at the inlet/outlet, temperatures across the reactor, operation recipe and ammonia production over time are displayed dynamically to evaluate the performance of the reactor. Future versions will include optimization features, such as the identification of optimal operating modes, the reduction of production time, an increase of productivity, and catalyst degradation estimation.
The SENDER (Sustainable Consumer Engagement and Demand Response) project aims to develop an innovative interface that engages energy consumers in Demand Response (DR) programs by developing new technologies to predict energy consumption, enhance market flexibility, and manage the exploitation of Renewable Energy Sources (RES). The current paper presents a replication study for consumer Digital Twins (DTs) that simulate energy consumption patterns and occupancy behaviors in various households across three pilot sites (Austria, Spain, Finland) based on six-month historical and real-time data related to loads, sensors, and relevant details for every household. Due to data limitations and inhomogeneity, we conducted a replication analysis focusing only on Austria and Spain, where available data regarding power and motion alarm sensors were sufficient, leading to a replication scenario by gradually increasing the number of households. In addition to limited data and short time of measurements, other challenges faced included inconsistencies in sensor installations and limited information on occupancy. In order to ensure reliable results, data was filtered, and households with common characteristics were grouped together to improve accuracy and consistency in DT modeling. Finally, it was concluded that a successful replication procedure requires sufficient continuous, frequent, and homogeneous data, along with its validation.