The random nature of wind energy is an important reason for the low energy utilization rate of wind farms. The use of a compressed air energy storage system (CAES) can help reduce the random characteristics of wind power generation while also increasing the utilization rate of wind energy. However, the unreasonable capacity allocation of the CAES system results in high capital investment and a long payback period. In order to improve the economic benefits of energy storage, this paper studies the capacity configuration of compressed air energy storage systems under the condition of wind energy uncertainty. First, the typical hourly power distribution of wind power generation was obtained using historical data. Factors such as user load demand, time-of-use price of the power grid, system investment cost, power shortage cost, and power sales revenue were considered. Then, a model was built with the charging and discharging power and gas storage capacity of the CAES system as constraints, and the maximum return on investment and the minimum volume of the gas storage tank as targets. NSGA-II and TOPSIS optimal selection methods were used to solve the problem. Finally, the model was used to optimize a power operation case. The results show that in the case of an hourly load power demand of a factory using 3.2 MW, a wind farm would need to keep four wind turbines running every day, and a compressed air energy storage system with a rated power of 1 MW and a rated capacity of 7 MW would ensure the best project benefit. In this mode, 1.24 × 103 MWh of wind abandoning power could be reduced annually, 2.6 × 104 kg of carbon emissions could be reduced by increasing energy storage within the operation cycle, and the payback period of investment would only be 4.8 years.
Intake valve parameters significantly affect the performance of the piston-type expander (PTE). To improve compressed energy utilization efficiency, intake valve parameters need to be regulated according to load. In this paper, an electro-pneumatic variable valve actuation (EPVVA) system was proposed for independent control distributing valve parameters. The trajectory planning for the intake valve was proposed to obtain good mechanical properties. Then, the intake valve duration angle was optimized, and the optimum intake valve lift curves were obtained at different rotational speeds. Results show that the energy efficiency decreased with the intake valve duration angle increasing. The output power ascended sharply with increasing intake valve duration angle, but the amplitude of power growth decreased. The output power had a maximum value at a specific intake valve duration angle. The gray relation analysis (GRA) method was applied to obtain the optimum intake duration angle based on output power and energy efficiency. Finally, the optimum intake valve trajectories were presented under different rotational speeds. Results are helpful for the future control of the piston-type expander.