In this brief review, we discuss the recent advancements in using poly(ethylene glycol) diacrylate (PEGDA) hydrogels for tissue engineering applications. PEGDA hydrogels are highly attractive in biomedical and biotechnology fields due to their soft and hydrated properties that can replicate living tissues. These hydrogels can be manipulated using light, heat, and cross-linkers to achieve desirable functionalities. Unlike previous reviews that focused solely on material design and fabrication of bioactive hydrogels and their cell viability and interactions with the extracellular matrix (ECM), we compare the traditional bulk photo-crosslinking method with the latest three-dimensional (3D) printing of PEGDA hydrogels. We present detailed evidence combining the physical, chemical, bulk, and localized mechanical characteristics, including their composition, fabrication methods, experimental conditions, and reported mechanical properties of bulk and 3D printed PEGDA hydrogels. Furthermore, we highlight the current state of biomedical applications of 3D PEGDA hydrogels in tissue engineering and organ-on-chip devices over the last 20 years. Finally, we delve into the current obstacles and future possibilities in the field of engineering 3D layer-by-layer (LbL) PEGDA hydrogels for tissue engineering and organ-on-chip devices.
Additive Manufacturing presents unique advantages over traditional manufacturing processes and has the potential to accelerate technical advancement across multiple sectors, permitting far greater freedom in design than conventional manufacturing. However, one barrier which blocks wide adoption is residual stresses, which could seriously affect the materials’ behaviour during and after production. Selective laser sintering (SLS), a process with high energy input to the workpiece material, induces high temperature gradients, further affecting the final residual stress distribution. Within the present paper, three different methods for the assessment of the residual stresses’ distribution are presented and compared: a non-destructive method based on neutron diffraction, a destructive method known as the contour method, and a theoretical approach based on Finite Element Analysis. The aim is to examine the suitability and reliability of the application of these methods in predicting residual stresses distribution in additive manufacturing-built parts.
Stainless steel, polymethylmethacrylate and polytetrafluoroethylene coupons were analysed for surface topographical and adhesion force characteristics using tapping mode atomic force microscopy and force-distance microscopy techniques. The two polymer materials were surface modified by polishing with silicon carbide papers of known grade. The struvite scaling rate was determined for each coupon and related to the data gained from the surface analysis. The scaling rate correlated well with adhesion force measurements indicating that lower energy materials scale at a lower rate. The techniques outlined in the paper provide a method for the rapid screening of materials in potential scaling applications.
A submerged jet-impingement flow loop was used to investigate corrosion control of an X65 steel weldment in flowing brine, saturated with 1 bar carbon dioxide, and containing a typical oilfield corrosion inhibitor. A novel jet-impingement target was constructed from samples of parent material, weld metal and heat affected zone, and subjected to flowing brine at velocities up to 10 ms-1, to give a range of hydrodynamic conditions ranging from stagnation to high turbulence. The galvanic currents between the electrodes in each hydrodynamic zone were recorded using zero-resistance ammeters and their self-corrosion rates were measured using the linear polarisation technique. At low flow rates, the galvanic currents were small and in some cases the weld metal and heat affected zone were partially protected by the sacrificial corrosion of the parent material. However, at higher flow rates the currents increased and current reversals sometimes took place leading to accelerated corrosion of the weld region. The most severe corrosion occurred when oxygen was deliberately admitted into the flow loop to simulate typical oilfield conditions. The results are explained in terms of the selective removal of the inhibitor film from different regions of the weldment at high flow rates and the corrosion mechanism in the presence of oxygen is discussed.