The macroscopic viscosity of polymer solutions in general differs strongly from the viscosity at the nanometer scale, and the relation between the two can be complicated. To investigate this relation, we use a fluorescent molecular rotor that probes the local viscosity of its molecular environment. For a range of chain lengths and concentrations, the dependence of the fluorescence on the macroscopic viscosity is well described by the classical Förster–Hoffmann (FH) equation, but the value of the FH exponent depends on the polymer chain length. We show that all data can be collapsed onto a master curve by plotting the fluorescence versus polymer concentration, which we explain in terms of the characteristic mesh size of the polymer solution. Using known scaling laws for polymers then allows us to quantitatively explain the relation between the FH exponent and the polymer chain length, allowing us to link the nano- to the macroviscosity.
We investigate the local viscosity of a polymer glass around its glass transition temperature by using environment-sensitive fluorescent molecular rotors embedded in the polymer matrix. The fluorescence of the rotors depends on the local viscosity, and measuring the fluorescence intensity and lifetime of the probe therefore allows us to measure the local free volume in the polymer glass when going through the glass transition. This also allows us to study the local viscosity and free volume when the polymer film is put under an external stress. We find that the film does not flow homogeneously but undergoes shear banding that is visible as a spatially varying free volume and viscosity.
11 January 2024 in The Journal of Physical Chemistry Letters
The sol-gel transition involves the transformation of a colloidal suspension into a system-spanning, interconnected gel. This process is widely used to reinforce mechanically weakened porous artifacts, such as sculptures but the impact of the restricted geometry (porous network) on the gelation dynamics of the solution remains unclear. Here, using fluorescent viscosity-sensitive molecular rotors, confocal microscopy, and model pores, we visualize the local viscosity changes at the microscale that accompany the sol-gel transition of a methyltriethoxysilane solution into a gel network. We show that, with evaporation of the solvent, a viscosity gradient develops near the free surface, triggering the sol-gel transition inside small pores near the surface. In homogeneous porous media, this leads to skin formation, which reduces the evaporation rate. In heterogeneous porous media, a gradient in gel density develops toward the heart of the porous material, where the gel formation mainly occurs as capillary bridges within smaller pores.
A droplet of surfactant spreading on an ultrasoft (E ≲ 100 Pa) gel substrate will produce capillary fractures at the gel surface; these fractures originate at the contact-line and propagate outwards in a starburst pattern. There is an inherent variability in both the number of fractures formed and the time delay before fractures form. In the regime where single fractures form, we observe a Weibull-like distribution of delay times, consistent with a thermally-activated process. The shape parameter is close to 1 for softer gels (a Poisson process), and larger for stiffer gels (indicative of aging). For single fractures, the characteristic delay time is primarily set by the elastocapillary length of the system, calculated from the differential in surface tension between the droplet and the substrate, rather than the elastic modulus as for stiffer systems. For multiple fractures, all fractures appear simultaneously and long delay times are suppressed. The experimental protocol provides a new technique for probing the energy landscape and fracture toughness of ultrasoft materials through measurement of the delay time distribution.