Here we report strong enhancement in ultraviolet-photoluminescence (UV-PL) of ZnO thin films (grown on a SiC substrate) covered by monolayer dielectric fused silica or polystyrene microspheres with diameters ranging from 0.5 to 7.5 μm. The excited light scatted in the film is collected by the microspheres to stimulate whispering gallery modes, by which the internal quantum efficiency of spontaneous emission is enhanced. Meanwhile, the microsphere monolayer efficiently couples emitted light energy from the luminescent film to the far-field for PL detection. A UV-PL enhancement up to 10-fold via a 5-µm-diameter microsphere monolayer is experimentally demonstrated in this work. The unique optical property of microsphere in photoluminescence (PL) enhancement makes them promising for high-sensitivity PL measurements as well as design of photoelectric devices with low loss and high efficiency.
This letter describes the increase in electrical conductivity of poly(vinylidene fluoride) induced by excimer laser irradiation with λ=248nm. The electrical conductivity was found to increase from 10−13to10−4Ω−1cm−1. As a result, experiments produced a transition in the property of the material from an insulator to a conductor. Optimal conditions for laser irradiation were determined in terms of the laser energy density, the repetition frequency, and the total number of laser shots. This letter also discusses the micromechanics of increasing conductivity in the light of Raman spectroscopy and x-ray photoelectron spectroscopy.
This work describes a method for rapidly and conveniently fabricating high-performance conductive patterns on poly (vinylidene fluoride) substrates using a 248nm excimer laser. It shows that the artificial active centre, created by laser direct etching technique, could facilely control the formation of modified layer, avoiding the laser threshold in processing. Using the etching lines to structure the nonconductive paths, the controllable patterns can be formed in selective areas through the designed photo-mask when 248nm laser irradiation. The modified layer exhibits a high-grade electrical conductivity of 2.80 Ω−1cm−1 increased by 13 orders of magnitude, and the considerable improvement in conductivity could be attributed to the carbon enrichment, especially the structural formation of C-C.