Mechanical control systems structure, derived from Euler–Lagrange dynamics, is directly tied to physically meaningful coordinates such as joint angles, positions, and velocities. This work investigates when a mechanical control system can be transformed, without changing its physical coordinates, into an equivalent form whose Christoffel symbols vanish, thereby eliminating the configuration-dependent coupling terms in the inertia matrix. We establish a necessary and sufficient condition under which a mechanical control system can, via pure mechanical feedback, be transformed into an equivalent system with zero Christoffel symbols. For three representative examples of mechanical systems, we extensively discuss the global stabilization problem. These case studies demonstrate, respectively, global linearization; local linearization with singularities that can be globalized through an appropriate switching control strategy; and partial linearization, where eliminating the Christoffel symbols enables the design of a globally stabilizing nonlinear controller for a system that is not fully feedback linearizable. These findings demonstrate that achieving vanishing Christoffel symbols, while preserving physically meaningful coordinates, provides a powerful and broadly applicable tool for addressing complex control problems.
The aim of this work is to present an automatic solution to control the surveillance camera merely by the movements of the operator’s head. The method uses convolutional neural networks that work in a course-to-fine manner to estimate head orientation in image data. First, the image frame of the operator’s head is acquired from the camera on the operator’s side of the system. The exact position of a head, given by its bounding box, is estimated by a Multitask Cascaded Convolutional Network. Second, the customized network for a given scenario is used to classify the orientation of the head-on image data. In particular, the dedicated image dataset was collected for training purposes and was given a discrete set of possible orientations in the vertical and horizontal planes. The accuracy of the estimators is higher than , with an average of fps of validation time. Finally, the current head orientation data are converted into a control signal for two degrees of freedom surveillance camera mounting. The feedback response time is s, which is sufficient for most real-life surveillance applications.
In this paper, we present a fully automatic solution for denoting bone configuration on two-dimensional images. A dataset of 300 X-ray images of children’s knee joints was collected. The strict experimental protocol established in this study increased the difficulty of post-processing. Therefore, we tackled the problem of obtaining reliable information from medical image data of insufficient quality. We proposed a set of features that unambiguously denoted configuration of the bone on the image, namely the femur. It was crucial to define the features that were independent of age, since age variability of subjects was high. Subsequently, we defined image keypoints directly corresponding to those features. Their positions were used to determine the coordinate system denoting femur configuration. A complex keypoint detector was proposed, composed of two different estimator architectures: gradient-based and based on the convolutional neural network. The positions of the keypoints were used to determine the configuration of the femur on each image frame. The overall performance of both estimators working in parallel was evaluated using X-ray images from the publicly available LERA dataset.
The objective of this study is to design and verify a decision system intended for the automatic sorting of metal components cut using laser technology. Laser cutting is one of the most precise methods of metal processing; however, the manual extraction and sorting of cut components limit the overall efficiency of the process. The proposed system integrates a KUKA KR 6 R900 sixx robotic manipulator equipped with a vacuum gripper and a vision system, enabling automation of the transportation and classification of parts. A key component of the system is a decision algorithm that, based on G-code data, determines the suction cup attachment points while taking into account the mass and dimensions of the components. The study considers a variety of materials and shapes, such as structural steel and aluminum of different thicknesses. Simulation and experimental results confirmed the effectiveness of the proposed solution in transferring and assigning components to storage locations. This work presents a proposal for a modern automation system that can be applied in the metalworking industry. The presented solution is a prototype developed on a reduced scale, which allowed for verification of system performance while meeting the design assumptions.
21 August 2025 in Biomedical Signal Processing and Control