The physical and mechanical properties of rocks change significantly after being subjected to high temperatures, which poses safety hazards to underground projects such as coal underground gasification. In order to investigate the effect of temperature on the macroscopic and microscopic properties of rocks, this paper has taken sandstone as the research object and conducted uniaxial compression tests on sandstone specimens at different temperatures (20–1000 °C) and different heating rates (5–30 °C/min). At the same time, the acoustic emission (AE) test system was used to observe the acoustic emission characteristics of the rock damage process, and the microstructural changes after high temperature were analyzed with the help of a scanning electron microscope (SEM). The test results show that the effect of temperature on sandstone is mainly divided into three stages: Stage I (20–500 °C) is the strengthening zone, the evaporation of water and the contraction of primary fissures, and sandstone densification is enhanced. In particular, the compressive strength and elastic modulus increase, the macroscopic damage mode is dominated by shear damage, and the fracture micromorphology is mainly brittle fracture. Stage II (500–600 °C) is the transition zone, 500 °C is the threshold temperature for the compressive strength and modulus of elasticity, and the damage mode changes from shear to cleavage damage, and the sandstone undergoes brittle–ductile transition in this temperature interval. Stage III is the physicochemical deterioration stage. The changes in the physical and chemical properties make the sandstone compressive strength and modulus of elasticity continue to decline, the macroscopic damage mode is mainly dominated by cleavage damage, and the fracture microscopic morphology is of a more toughness fracture. The effect of different heating rates on the mechanical properties of sandstone was further studied, and it was found that the mechanical properties of the rock further deteriorated under higher heating rates.

Solid backfill coal mining (SBCM) is a green mining technology which can effectively alleviate the environmental problems induced by traditional coal mining techniques, such as surface subsidence, water resources loss, coal gangue occupation, and pollution. In this study, a multilayer Winkler foundation beam model for the overburden key strata is proposed, and the model with two key strata is solved. The subsidence, rotating angle, inner force, and stress of the overburden key strata are systematically analyzed under various backfill elastic modulus, mining height, and soft layer thickness. The results show that the subsidence of the key strata exhibit “basin”-shape curves, and the backfill elastic modulus, mining height, and the thickness of the soft strata have significant influences on the subsidence of the key strata. The shear stress, horizontal stress, and vertical stress of key stratum can be effectively reduced by increasing the backfill elastic modulus. The increase of mining height has little influence on the stress of key stratum that close to the coal seam (key stratum #1), but has a significant effect on the stress of key stratum that above the soft layers (key stratum #2). On the contrary, the effect of increasing soft layer thickness on the stress of key stratum is opposite to that of increasing mining height. In addition, the shear failure of key stratum #1 at mining boundary and the tensile failures on both sides of mining boundary should be preferentially considered in SBCM engineering design. Due to the low shear stress level of key stratum #2, the tensile failure on both sides of the mining boundary should be mainly considered.

The deformation behavior of rolled Mg alloy AZ31, previously compressed along the rolling direction (RD), was numerically investigated under reverse tension. The EVPSC-TDT model was employed to study the effect of pre-strain on detwinning for 3%, 6% and 9% pre-compressed materials along the RD. A new criterion was proposed to control the exhaustion of detwinning under reverse tension. Numerical results show good agreement with the corresponding experimental data. It was demonstrated that the proposed criteria can capture the key features associated with detwinning in pre-compressed materials. Regardless of the amount of pre-compression, detwinning is activated under reverse tension, leading to low yield stress and a typical s-shaped flow curve. The inflection point reflects the exhaustion of detwinning, which is delayed when increasing the amount of pre-compression.