Fuel load is the key factor driving fire ignition, spread and intensity. The current literature reports the light detection and ranging (LiDAR), optical and airborne synthetic aperture radar (SAR) data for fuel load estimation, but the optical and SAR data are generally individually explored. Optical and SAR data are expected to be sensitive to different types of fuel loads because of their different imaging mechanisms. Optical data mainly captures the characteristics of leaf and forest canopy, while the latter is more sensitive to forest vertical structures due to its strong penetrability. This study aims to explore the performance of Landsat Enhanced Thematic Mapper Plus (ETM+) and Advanced Land Observing Satellite (ALOS) Phased Arrayed L-band Synthetic Aperture Radar (PALSAR) data as well as their combination on estimating three different types of fuel load—stem fuel load (SFL), branch fuel load (BFL) and foliage fuel load (FFL). We first analyzed the correlation between the three types of fuel load and optical and SAR data. Then, the partial least squares regression (PLSR) was used to build the fuel load estimation models based on the fuel load measurements from Vindeln, Sweden, and variables derived from optical and SAR data. Based on the leave-one-out cross-validation (LOOCV) method, results show that L-band SAR data performed well on all three types of fuel load (R2 = 0.72, 0.70, 0.72). The optical data performed best for FFL estimation (R2 = 0.66), followed by BFL (R2 = 0.56) and SFL (R2 = 0.37). Further improvements were found for the SFL, BFL and FFL estimation when integrating optical and SAR data (R2 = 0.76, 0.81, 0.82), highlighting the importance of data selection and combination for fuel load estimation.
P-band PolInSAR has the potential to map forest height and biomass at the global scale with the upcoming BIOMASS mission. However, because of the strong penetration of P-band and temporal decorrelation of repeat-pass observations, volume temporal decorrelation (γ VT ), ground temporal decorrelation (γ GT ), and residual ground scattering ( mmin ) largely influence forest height inversion. By integrating the random volume over ground (RVoG) model and Sum of Kronecker Products (SKP) decomposition, this study proposed a multi-baseline forest height inversion method to remove the joint influence of these problems. The theoretical simulation and empirical experiments using airborne P-band PolInSAR data in tropical forests, Nouragues, explicitly explored how each of the three problems affects the inversion. γ VT and mmin generally affect forest height inversion more than γ GT , and the concurrence of them brought severe overestimation to RVoG inversions (RMSE ranges from 7.6 to 18.8 m). Stepwise comparisons show that compensating for each of γ GT , γ VT , and mmin could improve the inversion accuracy further. The proposed multi-baseline inversion simultaneously solved all three problems and produced the best accuracy (RMSE of 3.4 m), and it has a stable performance for another two more different multi-baseline datasets, producing similar inversion accuracies (RMSE of 3.3 and 3.6 m). The additional experiment using BIOSAR 2007 datasets with varied temporal baselines of 0 day, 30 days, and 56 days demonstrated that the proposed method has stability against temporal decorrelation. Consequently, the proposed method improved both the accuracy and robustness of forest height inversion.
7 March 2026 in International Journal of Applied Earth Observation and Geoinformation