Extensive research has been conducted on the uniaxial tensile and compressive behavior of engineered cementitious composites. Despite the high tensile ductility and high toughness of engineered cementitious composites, transverse steel reinforcement is still necessary for high-performance structural members made of engineered cementitious composites. However, very limited research has been concerned with the compressive behavior of steel-confined engineered cementitious composites. This article presents the results of axial compression tests on a series of circular engineered cementitious composite columns confined with steel spirals. The test variables included the engineered cementitious composite compressive strength, the spiral pitch, and the spiral yield stress. The test results show that steel-confined engineered cementitious composites in the test columns exhibited a very ductile behavior; the steel spiral confinement contributed effectively to the enhancement of both strength and ductility of engineered cementitious composites. The test results were then interpreted by comparing them with the predictions from some existing models. It was found that the existing models previously developed for confined concrete failed to predict the compressive strength of steel-confined engineered cementitious composites with sufficient accuracy. New fitting equations for the compressive properties of steel-confined engineered cementitious composites were then obtained on the basis of the test results of this study as well as those from an existing study.
1 October 2018 in Journal of Structural Engineering
In coupled shear wall or core wall systems, reinforced-concrete (RC) coupling beams are crucial to the seismic performance of the overall structure. These coupling RC beams, however, tend to undergo brittle shear failure, especially those with a small span-to-depth ratio (i.e., deep coupling beams). In this paper, an alternative RC coupling beam with high seismic resistance and high ductile behavior is proposed. The coupling beam is made of high-toughness concrete reinforced with an embedded vertical steel plate as well as steel bars. Three proposed steel plate–reinforced high toughness–concrete (PRHTC) coupling beams with different span-to-depth ratios ( , 1.5, and 2.0) were tested. All three PRHTC coupling beams behaved in a ductile manner with good hysteretic behavior and large energy-dissipating capacity. Both the embedded steel plates and the high-toughness concrete contributed greatly to the high performance of the PRHTC coupling beams. The test results also show that load-carrying capacity of the PRHTC coupling beams increases as the span-to-depth ratio decreased whereas deformation ductility remains stable.