Rafail Isemin

Mr. Rafail Isemin


Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2019 in Fuel
Verified
Journal Article
Closed access
RIRafail Isemin
Rafail Isemin
DKDmitry Klimov
Dmitry Klimov
OLOlga Larina
Olga Larina
GSGeorgy Sytchev
Georgy Sytchev
VZVictor Zaichenko
Victor Zaichenko
OMOleg Milovanov
Oleg Milovanov

20 November 2021 in Processes
Verified
Journal Article
Open access
PDF file
RIRafail Isemin
Rafail Isemin
NMNatalia Muratova
Natalia Muratova
SKSergey Kuzmin
Sergey Kuzmin
DKDmitry Klimov
Dmitry Klimov
VKVadim Kokh-Tatarenko
Vadim Kokh-Tatarenko
BRBernd Rogge
Bernd Rogge
Poultry farms with floor-standing poultry generate large amounts of poultry litter waste. The direct application of this waste as an organic fertilizer does not ensure sustainable and cost-efficient utilization of all waste fractions, and can also be linked to environmental hazards. Therefore, the development of new technologies is required for processing poultry litter into a safe product with higher added value. In this work, the characteristics of activated carbon derived from hydrochar, along with the liquid products obtained from hydrothermal carbonization (HTC) and the wet torrefaction (WT) of poultry litter, were investigated. Poultry litter (PL) was applied in a mixture with sawdust (SD) in the following ratios: 1:0 (PL/SD 1:0), 1:1 (PL/SD 1:1), 1:2 (PL/SD 1:2), and 2:1 (PL/SD 2:1). WT processing took place in an innovative fluidized bed system in a superheated steam medium with low overpressure (less than 0.07 MPa) at 300 °C and 350 °C for 30–45 min. Conventional HTC processing was performed in a water medium at 220 °C for 1–4 h. The hydrochar produced in the experiments was activated with steam for 1 h at 450–750 °C. The porosity characteristics of activated hydrochar were measured, including pore size, pore volume, and specific surface area, in view of potential industrial applications as an adsorbent. Additionally, the contents of 5-hydroxymethylfurfural (HMF), as high-value product, were determined in the liquid products obtained from HTC processing, as well as in the condensate obtained after WT processing. Specific surface areas of the activated hydrochars may still be too low for application as adsorbent material. Hence, its use as a biofertilizer and soil improver should be preferred. Interestingly, the liquid fraction obtained from the innovative WT process displayed a significantly higher 5-HMF content compared to the conventional HTC process.

23 January 2013 in Waste and Biomass Valorization
Verified
Journal Article
Closed access
PDF file
Nikolopoulos NikolaosNikolopoulos Nikolaos
Nikolopoulos Nikolaos
RIRafail Isemin
Rafail Isemin
Konstantinos AtsoniosKonstantinos Atsonios
Konstantinos Atsonios
DKDimitrios Sotirios Kourkoumpas
Dimitrios Sotirios Kourkoumpas
SKS. Kuzmin
S. Kuzmin
Emmanuel KakarasEmmanuel Kakaras
Emmanuel Kakaras

15 March 2022 in Energies
Verified
Journal Article
Open access
PDF file
RIRafail Isemin
Rafail Isemin
AMAlexander Mikhalev
Alexander Mikhalev
OMOleg Milovanov
Oleg Milovanov
DKDmitry Klimov
Dmitry Klimov
VKVadim Kokh-Tatarenko
Vadim Kokh-Tatarenko
VKValentin Konyakhin
Valentin Konyakhin
Torrefaction is a technology for the preliminary thermochemical treatment of biomass in order to improve its fuel characteristics. The aim of this work is to conduct comparative studies and select the optimal operating conditions of fluidized bed torrefaction for the processing of poultry litter (PL) into an environmentally friendly fuel. PL torrefaction was evaluated according to three different process configurations: (1) torrefaction of PL pellets in a fixed bed in a nitrogen medium at temperatures of 250 °C, 300 °C and 350 °C (NT1, NT2 and NT3); (2) torrefaction of PL pellets in a fluidized bed of quartz sand in a nitrogen medium at temperatures of 250 °C, 300 °C and 350 °C (NT4, NT5 and NT6); and (3) torrefaction of PL pellets in a fluidized bed of quartz sand in an environment of superheated steam at temperatures of 250 °C, 300 °C and 350 °C (ST1, ST2 and ST3). The duration of the torrefaction process in all experiments was determined by the time required for completion of CO2, CO, H2, and CH4 release from the treated biomass samples. The gas analyzer (Vario Plus Syngaz) was used to measure the concentration of these gases. The torrefaction process began from the moment of loading the PL sample into the reactor, which was heated to the required temperature. After the start of the torrefaction process, the concentration of CO2, CO, H2, and CH4 in the gases leaving the reactor initially increased and, subsequently, dropped sharply, indicating the completion of the torrefaction process. The chemical composition of the obtained biochar was studied, and it was found that the biochar contained approximately equal amounts of oxygen, carbon, nitrogen, hydrogen and ash, regardless of the torrefaction method. Furthermore, the biogas yield of the liquid condensate, obtained from the cooling of superheated steam used in the torrefaction process, was evaluated. The results highlight the efficiency of fluidized bed torrefaction, as well as the performance of superheated steam as a fluidization medium.

24 June 2019 in Thermal Engineering
Verified
Journal Article
Closed access
PDF file
RIR. L. Isemin
R. L. Isemin
AMA. V. Mikhalev
A. V. Mikhalev
NMN. S. Muratova
N. S. Muratova
VKV. S. Kogh-Tatarenko
V. S. Kogh-Tatarenko
YTYuri Teplitsky
Yuri Teplitsky
EPE. A. Pitsukha
E. A. Pitsukha
Russia faces an important environmental challenge associated with the accumulation of a large amount of biowaste due to the lack of technologies for their efficient processing. In particular,...

14 January 2026 in Fermentation
Verified
Journal Article
Open access
PDF file
GSGabrielly Karla Silva Santos
Gabrielly Karla Silva Santos
Carlos Eduardo De Farias SilvaCarlos Eduardo De Farias Silva
Carlos Eduardo De Farias Silva
BGBrígida Gama
Brígida Gama
JMJosimayra Almeida Medeiros
Josimayra Almeida Medeiros
MBMathieu Brulé
Mathieu Brulé
AAAna Karla de Souza A K S de Souza Abud
Ana Karla de Souza A K S de Souza Abud
Driven by the energy transition within the framework of the United Nations Framework Convention on Climate Change, second-generation (2G) ethanol stands out as a technical and sustainable alternative to fossil fuels. Although first-generation ethanol, produced from saccharine and starchy feedstocks, represents an advance in mitigating emissions, its expansion is limited by competition with areas destined for food production. In this context, 2G ethanol, obtained from residual lignocellulosic biomass, emerges as a strategic route for diversifying and expanding the renewable energy matrix. Thus, this work discusses the current state of 2G ethanol technology based on the gradual growth in production and the consolidation of this route over the last few years. Industrial second-generation ethanol plants operating around the world demonstrate the high potential of agricultural waste as a raw material, particularly corn straw in the United States, which offers a lower cost and significant yield in the production of this biofuel. Similarly, in Brazil, sugarcane by-products, especially bagasse and straw, are consolidating as the main sources for 2G ethanol, integrated into the biorefinery concept and the valorization of by-products obtained during the 2G ethanol production process. However, despite the wide availability of lignocellulosic biomass and its high productive potential, the consolidation of 2G ethanol is still conditioned by technical and economic challenges, especially the high costs associated with pretreatment stages and enzymatic cocktails, as well as the formation of inhibitory compounds that compromise the efficiency of the process. Genetic engineering plays a particularly important role in the development of microorganisms to produce more efficient enzymatic cocktails and to ferment hexoses and pentoses (C6 and C5 sugars) into ethanol. In this scenario, not only are technological limitations important but also public policies and tax incentives, combined with the integration of the biorefinery concept and the valorization of (by)products, which prove fundamental to reducing costs, increasing process efficiency, and ensuring the economic viability and sustainability of second-generation ethanol.