This work presents peculiarities of forming a structure, phase and chemical composition while welding medium-carbon steels (Steel 45) depending on a heat content of molten electrode metal droplets when using welding power sources having different power parameters. It was experimentally established that the power inverter provides the decreased heat input into droplets of electrode metal during the welding process. This stimulates obtaining a fine-grained structure of the deposited metal and heat affected zone, reduces the extent of the HAZ that enhances working properties of welded joints.
1 January 2018 in IOP Conference Series: Earth and Environmental Science
The paper presents results the research in the effect of power sources dynamic characteristics on stability of melting and electrode metal transfer to the weld pool shielded metal arc welding. It is proved that when applying inverter-type welding power sources, heat and mass transfer characteristics change, arc gap short-circuit time and drop generation time are reduced. This leads to reduction of weld pool heat content and contraction of the heat-affected zone by 36% in comparison the same parameters obtained using a diode rectifier.
14 September 2015 in IOP Conference Series: Materials Science and Engineering
This paper presents peculiar properties of structure formation, phase and chemical composition while welding of low-alloy steel 09MnSi2-l depending on the dynamic characteristics of power sources of different types. Proper selection of power sources enables to decrease burning of alloy elements in metal of weld (Mn by 14% and Si by 17% of the weight ratio), to obtain more homogenous structure of deposited metal, to reduce length of heat-affected zone by 50% and to improve impact strength by 4-9%.
1 April 2016 in IOP Conference Series: Materials Science and Engineering
This paper summarizes experience of application of nano-sized carbides and borides of titanium and chromium, silicon carbide as components of electro-depositable coating compositions based on nickel, zinc, and chromium. Basic physical and mechanical properties of the coatings are determined. Technological and economic evaluation is completed; practicability of high-cost nano-diamonds substitution for nano-sized borides and carbides is justified.
25 June 2021 in Devices and Methods of Measurements
The development of novel methods, scientific devices and means for measuring magnetic fields generated by ultra-low current is among promising directions in the development of medical equipment and instruments for geodetic surveys and space exploration. The present work is to develop a small sensor capable of detecting weak magnetic fields, which sources are biocurrents, radiation of far space objects and slight fluctuations of the geomagnetic field. Scientists estimate the strength of such magnetic fields as deciles of nanotesla. The key requirements for the sensors of ultra-low magnetic field are: resolution, noise level in the measurement channel, temperature stability, linearity and repeatability of the characteristics from one produced item to another. The aforementioned characteristics can be achieved by using planar technologies and microelectromechanical systems (MEMS) in such advanced sensors.The work describes a complete R&D cycle, from creating the computer model of the sensor under study to manufacturing of a working prototype. To assess the effect of the geometry and material properties, the Jiles–Atherton model is implemented which, unlike the majority of the models used, allows considering the non-linearity of the core, its hysteresis properties and influence of residual magnetization.The dimensions of the developed sensor are 40×20×5 mm, while the technology allows its further diminishment. The sensor has demonstrated the linearity of its properties in the range of magnetic field strength from 0.1 nT to 50 µT for a rms current of excitation of 1.25 mA at a frequency of 30 kHz. The average sensitivity for the second harmonic is 54 µV/nT.