Changes in mechanical properties of cells are closely related to a variety of diseases. As an advanced technology on the micro/nano scale, atomic force microscopy is the most suitable tool for information acquisition of living cells in human body fluids. AFMs are able to measure and characterize the mechanical properties of cells which can be used as effective markers to distinguish between different cell types and cells in different states (benign or cancerous). Therefore, they can be employed to obtain additional information to that obtained via the traditional biochemistry methods for better identifying and diagnosing cancer cells for humans, proposing better treatment methods and prognosis, and unravelling the pathogenesis of the disease. In this report, we review the use of AFMs in cancerous tissues, organs, and cancer cells cultured in vitro to obtain cellular mechanical properties, demonstrate and summarize the results of AFMs in cancer biology, and look forward to possible future applications and the direction of development.
9 October 2017 in Microscopy Research and Technique
This article studies the morphological and mechanical features of multinuclear and mononuclear SW480 colon cancer cells by atomic force microscopy to understand their drug‐resistance. The SW480 cells were incubated with the fullerenol concentrations of 1 mg/ml and 2 mg/ml. Morphological and mechanical features including the height, length, width, roughness, adhesion force and Young's modulus of three multinuclear cell groups and three mononuclear cell groups were imaged and analyzed. It was observed that the features of multinuclear cancer cells and mononuclear cancer cells were significantly different after the treatment with fullerenol. The experiment results indicated that the mononuclear SW480 cells were more sensitive to fullerenol than the multinuclear SW480 cells, and the multinuclear SW480 cells exhibited a stronger drug‐resistance than the mononuclear SW480 cells. This work provides a guideline for the treatments of multinuclear and mononuclear cancer cells with drugs.
Currently, global warming has been a serious issue, which is closely related to anthropogenic emission of Greenhouse Gas (GHG) in the atmosphere, particularly Carbon Dioxide (CO2). To help achieve carbon neutrality by decreasing CO2 emissions, Oxy-Fuel Combustion (OFC) technology is becoming a hot topic in recent years. However, few findings have been reported about the implementation of OFC in dual-injection Spark Ignition (SI) engines. This work numerically explores the effects of Water Injection (WI) strategies on OFC characteristics in a practical dual-injection engine, including GDI (only using GDI), P50-G50 (50% PFI and 50% GDI) and PFI (only using PFI). The findings will help build a conceptual and theoretical foundation for the implementation of OFC technology in dual-injection SI engines, as well as exploring a solution to increase engine efficiency. The results show that compared to Conventional Air Combustion (CAC), there is a significant increase in BSFC under OFC. Ignition delay () is significantly prolonged, and the spark timing is obviously advanced. Combustion duration () of PFI is a bit shorter than that of GDI and P50-G50. There is a small benefit to BSFC under a low water-fuel mass ratio (). However, with the further increase of from 0.2 to 0.9, there is an increment of 4.29%, 3.6% and 3.77% in BSFC for GDI, P50-G50 and PFI, respectively. As WI timing () postpones to around −30 °CA under the conditions of ≥ 0.8, BSFC has a sharp decrease of more than 6 g/kWh, and this decline is more evident under GDI injection strategy. The variation of maximum cylinder pressure () and combustion phasing is less affected by WI temperature () compared to the effects of or . BSFC just has a small decline with the increase of from 298 K to 368 K regardless of the injection strategy. Consequently, appropriate WI strategies are beneficial to OFC combustion in a dual-injection SI engine, but the benefit in fuel economy is limited.