Initial fertilisation, when the fertilizer is supplied during the plantation, is applied to improve the competitive ability of the seedlings and hence to increase their growth and productivity; however, fertilization could also alter wood properties and timber quality. In this study, the dimensions and tree-ring parameters – width, proportion of latewood, maximum and mean density, mean earlywood and latewood density – of initially fertilized (by 14, 6 and 11 g of N, P and K per seedling, respectively) Norway spruce ( Karst.) growing in an experimental plantation in Kalsnava, Latvia (temperate climate region) were assessed. The fertilization significantly increased the dimensions of trees in long-term (ca. 17% increase of stemwood volume). The analysis of tree-ring width suggested that the duration of the effect was ca. 15 years. The maximum and latewood density were higher for the fertilized trees only in a few years. The mean and earlywood density of tree-rings were mainly similar for both treatments. Altogether, considering the one-time application of a limited amount of fertilizer, such treatment had notable and lasting effect on Norway spruce.Picea abies

Solid wood production of hybrid aspen requires relative longer rotation periods, thus increasing risk of wood damages by pests and diseases. We compared damages by heart rot and poplar borer of 48 years old hybrid (Populus tremuloides Michx. × P. tremula L.) and European aspen in a progeny trial located in Eastern part of Latvia. Trees were harvested and rot patches and galleries were recorded and measured at a stump level. The number of galleries had positive relation on number of patches and total area of rot. The susceptibility of the rot and poplar borer was similar for both hybrid and European aspen. Yet, some differences among families were detected. No effect of pathogens damage was observed on the tree growth. Larger trees had smaller proportion and incidence of rot and galleries per unit of area as well as wider outer rot-free wood layer.

Fast-growing hybrids of L. have an increasing importance as a source of renewable energy and as industrial wood. Nevertheless, the long-term sensitivity of hybrids to weather conditions and hence to possible climatic hazards in Northern Europe have been insufficiently studied, likely due to the limited age of the trees (short rotation). In this study, the climatic sensitivity of ca. 65-year-old hybrid poplars ( L. × Ledeb.), growing at two sites in the western part of Latvia, and ca. 55-year-old hybrid aspens (Michx. × L.), growing in the eastern part of Latvia, have been studied using classical dendrochronological techniques. The high-frequency variation of tree-ring width (TRW) of hybrid poplar from both sites was similar, but it differed from hybrid aspen due to the diverse parental species and geographic location of the stands. Nevertheless, some common tendencies in TRW were observed for both hybrids. Climatic factors influencing TRW were generally similar for both hybrids, but their composition differed. The strength of climate-TRW relationships was similar, but the hybrid poplar was affected by a higher number of climatic factors. Hybrid poplar was sensitive to factors related to water deficit in late summer in the previous and current years. Hybrid aspen was sensitive to conditions in the year of formation of tree-ring. Both hybrids also displayed a reaction to temperature during the dormant period. The observed climate-growth relationships suggest that increasing temperatures might burden the radial growth of the studied hybrids of .Populus Populus Populus balsamifera P. laurifolia Populus tremuloides P. tremula Populus

Micropropagation of forest reproductive material is becoming an increasingly important tool of climate-smart forest management, whose efficiency is depending on artificial illumination, which in turn can have species-specific effects. To improve the energy-efficiency of micropropagation, light emitting diodes (LED) are becoming more popular; however, they emit light of narrow spectral composition, synergic effects of which can alter plantlet development. Regarding the in vitro cultures of trees, such effects have been scarcely studied. In this study, three clones of silver birch (Betula pendula Roth.) and three clones of hybrid aspen (Populus tremuloides Michx. × Populus tremula L.) from the eastern Baltic region were tested. The responses of leaf and stem anatomy of in vitro cultures to three LED light illumination treatments differing by spectral composition and to illumination by fluorescent tubes were estimated by linear (mixed) models. The studied light treatments had non-interacted effects on stomata density and on the secondary xylem cell wall in the stem of silver birch and in the stomata length, stem radius, and phloem width of hybrid aspen. Furthermore, clone-specific responses to illumination were observed for number of chloroplasts and phloem width of silver birch and for leaf thickness and xylem cell wall thickness of hybrid aspen, implying different mechanisms of shade avoidance. In general, the responses of plantlet anatomy differed according to the width of the light spectrum in case of LED, as well as for fluorescent tubes. Considering the legacy effects of early development of plantlets, adaptability of illumination in terms of spectral composition according to the requirements of genotypes appear highly beneficial for micropropagation of sustainable forest reproductive material.

Height growth of young hybrid aspen ( L. × Michx.) was studied in relation to weather conditions. Height of clones with different leaf flushing phenology (early, intermediate and late) was monitored during the growing periods of 2010 and 2011 in a plantation established on former agricultural land. Mean daily height increment (HI) was calculated. Multiple linear regression was used to determine which weather factors (variables) had significant effect on HI. Mean seasonal height growth (mean seasonal HI) between clones (groups) was compared by ANOVA. In both years, HI was significantly higher for clones with early and intermediate leaf flushing compared to clones with late leaf flushing. The effect of weather factors also differed between clones according to their leaf flushing phenology; it was the weakest for HI of clones with early leaf flushing compared to clones with intermediate and late leaf flushing. Mean temperature was the main factor, which positively affected HI of all clones, suggesting that warmer climate might be beneficial for height growth of young hybrid aspen in Latvia. Nevertheless, significant negative relationship between HI and potential evapotranspiration (PET) was observed for clones with delayed leaf flushing, suggesting negative effect of increasing variability of precipitation on growth. Thus, the differences in height growth intensity might be related to growth sensitivity to weather conditions. On the other hand, such differences in height growth between clones might be caused by competition (i.e. with herbs), as trees with early leaf flushing might conquer more resources and become more robust against the environmental fluctuation.Populus tremula P. tremuloides

Hybrid aspen (Populus tremula L. × Populus tremuloides Michx.) plantations may produce valuable sawlogs for the growing timber market and contribute to carbon sequestration. However, environmental risks such as stem rot, the spread of which is facilitated by insect or frost damage, may reduce the proportion of valuable timber. It is important to understand the various factors affecting the spread of aspen rot to mitigate negative impacts with tree breeding. This study aimed to assess the impact of frost cracks and large poplar borer on stem rot in hybrid aspen clones in two clonal trials in Latvia. Genetic parameters for the traits were also estimated. The presence of insect passages substantially increased the probability of stem rot without distinct clonal differences. A negative and mainly insignificant correlation was observed between rot and stem cracking. The highest broad-sense heritability (H² = 0.21) and strong site-site genotypic correlation (0.86) showed that the probability of stem rot is genetically determined in the study material. Significant differences in diameter at breast height, the presence of stem rot, and its severity were found among the clones, albeit without undesirable positive correlation between growth and presence of decay. This indicated its potential to improve both productivity and rot resistance.