Hydrogels warrant attention as a potential material for use in sustained pulmonary drug delivery due to their swelling and mucoadhesive features. Herein, hyaluronic acid (HA) is considered a promising material due to its therapeutic potential, the effect on lung inflammation, and possible utility as an excipient or drug carrier. In this study, the feasibility of using HA hydrogels (without a model drug) to engineer inhalation powders for controlled pulmonary drug delivery was assessed. A combination of chemical crosslinking and spray-drying was proposed as a novel methodology for the preparation of inhalation powders. Different crosslinkers (urea; UR and glutaraldehyde; GA) were exploited in the hydrogel formulation and the obtained powders were subjected to extensive characterization. Compositional analysis of the powders indicated a crosslinked structure of the hydrogels with sufficient thermal stability to withstand spray drying. The obtained microparticles presented a spherical shape with mean diameter particle sizes from 2.3 ± 1.1 to 3.2 ± 2.9 μm. Microparticles formed from HA crosslinked with GA exhibited a reasonable aerosolization performance (fine particle fraction estimated as 28 ± 2%), whereas lower values were obtained for the UR-based formulation. Likewise, swelling and stability in water were larger for GA than for UR, for which the results were very similar to those obtained for native (not crosslinked) HA. In conclusion, microparticles could successfully be produced from crosslinked HA, and the ones crosslinked by GA exhibited superior performance in terms of aerosolization and swelling.
The aim of this study was to investigate how the carrier morphology affects the expression of blend states in adhesive mixtures as a function of surface coverage ratio (SCR) and to identify where transitions between the different states occur. Adhesive mixtures of five lactose carriers with varying contents of lactose fines, corresponding to blends with different SCR ranging from 0 to 6, were produced by low-shear mixing. The powder mechanics of the mixtures were characterized by bulk density, compressibility and permeability. The appearance of the carriers and blends was studied by scanning electron microscopy, light microscopy and atomic force microscopy. The size and morphology of the carriers had a crucial impact on the evolution of the blend state, and affected the powder mechanical properties of the mixtures. It was found that smaller carriers with little or no surface irregularities were more sensitive to additions of fines resulting in self-agglomeration of fines at relatively low SCR values. On the contrary, carriers with irregular surface structures and larger sizes were able to reach higher SCR values before self-agglomeration of fines occurred. This could be attributed to an increased deagglomeration efficiency of irregular and larger carriers and to fines predominantly adhering to open pores.