Yemen is a water-scarce country with inadequate freshwater, considerable groundwater depletion, and a lack of adequate surface water. This study aims to assess water resources and identify the current water situation in Sana’a region, which includes the governorate of Sana’a and the country’s capital, Sana’a city. A variety of data from different sources was collected and analyzed. Remote sensing (RS) and GIS techniques in combination with the Arc Hydro model were utilized. Water demand and supply for domestic and agricultural purposes were estimated. The results show that there is insufficient water to meet the needs of the region’s yearly population growth rates of 3.2 and 4.5% in Sana’a governorate and Sana’a city, respectively. The amount of observed rainfall varies spatially and temporally, ranging between 160 and 367 mm per year. There are 233 water structures, 168 dams, and 65 reservoirs, with a storage capacity of 64.65 and 0.24 Mm3 (million cubic meters), respectively. In Sana’a basin, groundwater abstraction increased significantly from about 25 Mm3 in 1970 to around 330 Mm3 in 2020, while groundwater recharge was about 80 Mm3 in 2020. The estimated water demand for domestic use was in the range of approximately 106–128 and 199–241 Mm3 in Sana’a governorate, whereas in Sana’a city, it was in the range of about 249–302 and 607–737 Mm3 for 2020 and 2040, respectively. The estimated agriculture water demand was between 1.14 and 1.53 Bm3 (billion cubic meters) in 2007, and declined to 801 Mm3 and 1.16 Bm3 in 2018 due to the reduction in the cultivated area by about 33% from 2007 to 2018, which was attributed to a lack of water. The estimated water deficit ranges between 500 and 723 Mm3 during 2007 and 2018. This study concluded that the estimated water supply and demand for the past 12 years from 2007 to 2018 resulted in a supply that was less than the demand in each year, indicating that the available water resources were insufficient to fulfill demand. The significant gap between water supply and demand means withdrawal from the stored groundwater. Thus, groundwater is at high risk. Constructing more water harvesting structures, adopting water conservation, water resource management, and making groundwater artificial recharge are recommended to meet the water demand and conserve non-renewable resources in the coming decades. The results obtained from this study would help decision makers to make appropriate plans to achieve the SDGs in Sana’a region.
Dam numerical simulation is an important method to research the dam structural behavior, but it often takes a lot of time for calculation when facing problems that require many simulations, such as structural parameter back analysis. The surrogate model is widely used as a technology to reduce computational cost. Although various methods have been widely investigated, there are still problems in designing the surrogate model's optimal Design of Experiments (DoE). In addition, most of the current DoE focuses on establishing a single-output problem. Designing a reasonable DoE for high-dimensional outputs is also a problem that needs to be solved. Based on the above issues, this research proposes a sequential surrogate model based on the radial basis function model (RBFM) with multi-outputs adaptive sampling. The benchmark function demonstrates the applicability of the proposed method to single-input & multi-outputs and multi-inputs & multi-outputs problems. Then, this method is applied to establishing a surrogate model for dam numerical simulation with multi-outputs. The result demonstrates that the proposed technique can be sampled adaptively and samples can be targeted based on the function form of the surrogate model, which significantly reduces the required sampling and calculation cost.
29 April 2022 in Case Studies in Construction Materials