This paper investigates the aeroacoustic interactions of small hovering rotors, using both experiments and computations. The experiments were conducted in an anechoic chamber with arrays of microphones setup to evaluate the azimuthal and polar directivity. The computational methodology consists of high fidelity detached eddy simulations coupled to the Ffowcs-Williams and Hawkings equation, supplemented by a trailing edge broadband noise code. The aerodynamics and aeroacoustics of a single rotor are investigated first. The simulations capture a Reynolds number effect seen in the performance parameters that results in the coefficient of thrust changing with the RPM. The acoustic analysis enables the identification of self-induced noise sources. Next, dual side-by-side rotors are studied in both counter-rotating and co-rotating configurations to quantify the impact of their interactions. Higher harmonics appear due to the interactions and it is verified that the counter-rotating case leads to more noise and a less uniform azimuthal directivity. Difficulties that arise when trying to validate small rotor calculations against experiments are discussed. Comparisons of computational and experimental results yield further insight into the noise mechanisms that are captured by each methodology.
The high-fidelity rotorcraft simulation framework HPCMP CREATE-AV Helios was used to study the impact of turbulence modeling methods on the prediction of a small quadrotor unmanned aerial vehicle. ...
1 January 2023 in Journal of the American Helicopter Society
A multirotor trim algorithm is developed and validated using the HPCMP CREATE™-AV Helios rotorcraft analysis and simulation framework. Validation data were sourced from experiments in which a quadrotor with fixed-pitch rotors was trimmed for steady hover and forward flight in the NASA Langley Low-Speed Aeroacoustic Wind Tunnel. For each flight condition, the aircraft attitudes were fixed so that the only control variables were the rotation rates of the four rotors, which were varied until the residual loads were minimal. The resultant trim states were first replicated in the computational framework to verify the aerodynamic solver. Then, the trim algorithm was validated in Helios by constraining the aircraft attitudes and searching for the rotor speeds that minimized the residual loads. The analysis demonstrated excellent agreement between the predicted and measured trim states. Finally, free-flight trim cases were simulated to quantify the effect of the trim constraints and verify the experimentally trimmed flight conditions. The predicted free-flight trim state showed reasonable agreement to the constrained case, with negligible change in the residual loads, indicating trim was achieved in both the experiments and the simulations.