Hydraulic stimulation of geothermal reservoirs in low-permeability basement and crystalline igneous rock can enhance permeability by reactivation and shear dilation of existing fractures. The process is characterized by interaction between fluid flow, deformation, and the fractured structure of the formation. The flow is highly affected by the fracture network, which in turn is deformed because of hydromechanical stress changes caused by the fluid injection. This process-structure interaction is decisive for the outcome of hydraulic stimulation, and, in analysis of governing mechanisms, physics-based modeling has potential to complement field and experimental data. Here, we show how recently developed simulation technology is a valuable tool to understand governing mechanisms of hydromechanical coupled processes and the reactivation and deformation of faults. The methodology fully couples flow in faults and matrix with poroelastic matrix deformation and a contact mechanics model for the faults, including dilation because of slip. Key elements are high aspect ratios of faults and strong nonlinearities in highly coupled governing equations. Example simulations using our open-source software illustrate direct and indirect hydraulic fault reactivation and corresponding permeability enhancement. We investigate the effect of the fault and matrix permeability and the Biot coefficient. A higher matrix permeability leads to more leakage from a permeable fault and thus suppresses reactivation and slip of the fault compared to the case with a lower matrix permeability. If a fault is a barrier to flow, increase of pressure because of the fluid injection results in stabilization of the fault; the situation is opposite if the fault is highly permeable compared to the matrix. For the given setup, lowering the Biot coefficient results in more slip than the base case. While conceptually simple, the examples illustrate the strong hydromechanical couplings and the prospects of physics-based numerical models in investigating the dynamics.
Instantaneous heat transfer between different phases, known as local thermal equilibrium (LTE), is commonly assumed for modeling heat transfer in porous media. This assumption may not hold in certain technical and environmental applications, particularly with large temperature gradients, large differences in thermal properties, or high velocities. Local thermal non-equilibrium (LTNE) models aim to describe heat transfer processes when the LTE assumption may fail. We compare three continuum-scale models from the pore to the representative elementary volume (REV) scale. Specifically, dual-network and REV-scale models are evaluated against a pore-resolved model used as a reference in the absence of experimental results. Different effective models are used to obtain upscaled properties on the REV scale and to compare resulting temperature profiles. The systems investigated are fully saturated, consisting of one fluid and one solid phase. This study focuses on purely conductive systems without significant differences in thermal properties. Results show that LTE holds for low interfacial resistances. However, for large interfacial resistances, solid and fluid temperatures differ. The REV-scale model with effective parameters obtained by homogenization leads to similar results as the pore-resolved model, whereas the dual-network model deviates more due to fixed spatial resolution. Among the evaluated REV-scale formulations, only the homogenization-based approach captures the LTNE behavior, as it incorporates the interfacial heat transfer coefficient. Our results provide a basis for conduction-dominated heat transfer in saturated porous media and for further systematic comparisons that incorporate convection relevant to a broader range of applications.