WC–Co cemented carbides are geometrically complex composites constituted for two interpenetrating networks of the constitutive ceramic and metal phases. Accordingly, assessment of microstructural effects on the local mechanical properties of each phase is a challenging task, especially for the metallic binder. In this work, it is attempted by combining massive nanoindentation, statistical analysis, and implementation of a thin film model for deconvolution of the intrinsic hardness and flow stress of the metallic phase. Plotting of yield stress values as a function of the binder mean free path results in a Hall-Petch strengthening relationship with a slope (ky) of 0.98 MPa m1/2. This value points out the effectiveness of WC–Co phase boundaries as strong obstacles to slip propagation; and thus, for toughening of the brittle phase (WC) by means of crack-bridging ductile (Co) reinforcement.Peer ReviewedPostprint (author's final draft

In this work, shot peening was performed in a metastable austenitic stainless steel EN 1.4318 (AISI 301LN) in order to evaluate its effect on austenite to martensite phase transformation and also the influence on the fatigue limit. Two different steel conditions were considered: annealed, i.e., with a fully austenitic microstructure, and cold rolled, consisting of a mixture of austenite and martensite. X-ray diffraction, electron back-scattered diffraction and focus ion beam, as well as nanoindentation techniques, were used to elucidate deformation mechanisms activated during shot peening and correlate with fatigue response. Results pointed out that extensive plastic deformation and phase transformation developed in annealed specimens as a consequence of shot peening. However, the increase of roughness and the generation of microcracks led to a limited fatigue limit improvement. In contrast, shot peened cold rolled specimens exhibited enhanced fatigue limit. In the latter case, the main factor that determined the influence on the fatigue response was the distance from the injector, followed successively by the exit speed of the shots and the coverage factor. (C) 2015 Elsevier B.V. All rights reserved.Postprint (author’s final draft

The intrinsic hardness of the constitutive phases in WC–Co composites is investigated by combining experimental and statistical analysis nanoindentation techniques. It is done on the basis of considering the cemented carbide material as effectively heterogeneous at the microstructure scale, i.e. consisting of three phases defined by either different chemical nature (carbides and binder) or distinct carbide crystal orientation (i.e. with surface normal perpendicular to either basal or prismatic planes). As main outcome, experimentally measured and statistically significant intrinsic hardness values for the defined phases (WC and constrained metallic binder) are analyzed and determined. Besides the evidence of crystal anisotropy for the WC phase, they permit to identify and account the expected strengthening of the plastic-constrained metallic binder, a critical input parameter for hardness and toughness modelling as well as for microstructural design optimization of ceramic composites reinforced by ductile metallic ligamentsPeer ReviewedPostprint (author's final draft