In order to accurately analyze and evaluate multi-index and multi-route traffic schemes for comparison and selection, we introduce herein a comprehensive weight and an intelligent selection algorithm for traffic scheme optimization to improve upon the shortcomings of common qualitative and quantitative analysis methods. Firstly, we establish an evaluation index system of transportation by traffic scheme considering the factors of technology, ecological environment, social environment, and economy, based on the whole life cycle. Secondly, the comprehensive weight based on subjective and objective factors is constructed. Finally, we establish an optimization method for transportation schemes by using the comprehensive weight and Technique for Order Preference by Similarity to an Ideal Solution (TOPSIS) model. The results show that the evaluation index system based on the whole life cycle is more comprehensive and accurate. The comprehensive weight vector avoids the defects of single weight methods and makes full use of subjective data and expert opinions. The comprehensive weight vector is introduced into the decision-maker’s preference coefficient, so that analysts can determine the scheme according to the subjective and objective information and to the required accuracy. This method uses a large number of evaluation groups to evaluate the scheme, and the evaluation results show greater objectivity and efficiency.
Waste engine oil bottom (WEOB) is a hazardous waste whose effect as an additive to CR+SBS modified asphalt is rarely studied. In this study, the CR+SBS asphalt binder was modified with WEOB in different concentrations (3, 6, and 9 wt%). The GC–MS and FTIR were performed to evaluate the chemical compositions of WEOB and WEOBCR+SBS asphalt. The results showed that the main constituents of WEOB were similar to the functional groups of asphalt, along with maleic anhydride (MAH). Pavement performance-related rheological tests such as RV, temperature sweep (TS), FS, MSCR, and BBR were carried out. Results show that WEOBCR+SBS-6 exhibited the best high- and low-temperature property, followed by CR+SBS-3 and CR+SBS-9. Fluorescence microscope (FM) test, bar thin layer chromatograph (BTLC) test, FTIR, and AFM tests were carried out to evaluate the micro-morphologies and modification mechanism. The analysis revealed increased trends in resin fraction as opposed to asphaltene fraction with the increase of WEOB content. FTIR analysis revealed that the amide groups in WEOBCR+SBS asphalt bonded to the free radicals of CR. Moreover, a modification mechanism was elaborated. WEOB strengthens the cross-linked structure of CR+SBS polymers, reacting with SBS to graft onto MAH-g-SBS, and the free radical of CR interacts with the amide group in WEOB to form a bond. In addition, the content of lightweight components and surface roughness of SBS specimens were in good correlation, which contributed to the rutting resistance and adhesion and self-healing performance.
To study the characteristics of light and dark adaptation in tunnel portals, and to determine the influencing factors in light–dark vision adaptation, basic tunnel lighting and linear design data were obtained. In this study, we used a light-shielded tent to simulate the dark environment of a tunnel, observe the driver recognition time for target objects during the light–dark adaptation process, and analyze the light–dark adaptation time of human vision. Based on the experimental data, we examined the relationships between age, gender, illuminance, and light and dark adaptation times, and established a model for these relationships. The experimental results show that the dark adaptation time is generally longer than the light adaptation time. The dark adaptation time is positively related to age and exhibits a cubic relationship. There is no significant correlation between the light adaptation time and age, but the overall trend is for the light adaptation time to gradually increase with increasing age. There is no correlation between gender and light and dark adaptation times, but there is a notable correlation between light and dark adaptation times and illuminance. When the illuminance ranges from 11,000 to 13,000 lux, the light and dark adaptation times are the longest.
To study the characteristics of light and dark adaptation in tunnel portal sections and to determine the influencing factors of light-dark vision adaptation, basic tunnel lighting and linear design data are obtained. In this paper, we use a light-shielded tent to simulate the dark environment of a tunnel in experiments, observe the driver recognition time of target objects during the light-dark adaptation process, and analyze the light-dark adaptation time of human vision. Based on a large number of experimental data, we examined the relationship between age, gender, illuminance and light and dark adaptation times and established a model of the relationship between age, illuminance and light and dark adaptation times. The experimental results revealed that the dark adaptation time is generally longer than the light adaptation time. The dark adaptation time is positively related to age and basically exhibits a cubic relationship. There is no significant correlation between the light adaptation time and age, but the overall trend is that the light adaptation time gradually increases with increasing age. There is no correlation between gender and light and dark adaptation times, but there is a notable correlation between the light and dark adaptation times and illuminance. When the illuminance ranges from 11000-13000 lux, the light and dark adaptation times are the longest.
Because of the singular form and low flexibility of the clothoid as a highway transition curve in highway horizontal alignment, the K-curve, whose ratio of the chord-tangent angle to the tangential angle at any point is fixed, was proposed in a previous work, including the corresponding parametric equations and basic characteristics, and its high flexibility and various shapes were proved. Here, the application and verification of the K-curve in highway alignment is further studied. The solution methods of the K-curve for different connections are given. Through theoretical calculations and specific real-world examples, the geometric positions and lateral forces of the K-curve and the clothoid under different connection conditions are compared. The results show that the difference between the K-curve and clothoid in the above two aspects under a straight line-to-circle connection is greater than that under a circle-to-circle connection as an egg curve, and although the lateral force coefficient of the K-curve is smaller than that of the clothoid, the K-curve suffers from rapid change in the lateral force coefficient and a higher lateral acceleration change rate. Finally, the application conditions of the K-curve for highway alignment design are given with consideration of the centrifugal acceleration change rate.
To accurately analyze and evaluate the comparison and selection of multi-index and multi-route highway route schemes and address the disadvantages of traditional scheme evaluations, we focus on the economic costs of construction and improve on previous qualitative and quantitative analysis. A comprehensive weight and intelligent selection algorithm are introduced into the optimization of highway route schemes. This paper presents an evaluation index system for highway route schemes based on the full life cycle and considering technology, the ecological environment, the social environment and the economy. We propose an evaluation system for highway route schemes based on a comprehensive weight. Additionally, an optimization method for highway route schemes based on the TOPSIS model is studied. Finally, the optimal highway route scheme is obtained by calculation. According to the results of the research, the construction of evaluation indexes directly influences the results of the scheme evaluation. When established operations, management and maintenance indexes are based on the full life cycle, the evaluation results are more accurate. In addition to avoiding the defects of a single weighting method, the comprehensive weight vector uses subjective data as well as expert opinion. In addition, the comprehensive weight vector introduces a preference coefficient so that analysers can determine a scheme based on the accuracy of subjective and objective information and requirements. This method uses a large number of evaluation populations to evaluate schemes, and the result is more objective.