BiVO4 photocatalysts were synthesized via a facile surfactant-free method with heat treatment. The heat treatment temperatures influenced the crystal structures and morphologies. The photocatalytic performance is associated with its crystallinity, Brunauer–Emmett–Teller (BET) specific surface area, and band gap energy. The BiVO4 photocatalyst prepared by heat treatment at 700 °C showed the highest photocatalytic activity, promoting 100% degradation of methylene blue (MB) in 60 min under visible-light irradiation. Recycling experiments results indicated that the BiVO4 photocatalysts have excellent photo-stability, and a possible mechanism for the photocatalytic process was proposed by examining the effects of the active species involved in MB degradation. This work could provide new insights into the fabrication of highly efficient and stable BiVO4 photocatalysts for dye degradation.
Ce/La mixed rare-earth co-doped M-type strontium ferrite was successfully fabricated via a conventional solid-state sintering method, and the synergistic effects of pre-sintering oxygen partial pressure and temperature on the microstructure, elemental valence states, and magnetic performances of the prepared ferrite were systematically investigated. The influencing rules of pre-sintering oxygen partial pressure and heat treatment temperature on the precipitation of α-Fe2O3 impurity phase, lattice distortion behavior, grain growth characteristics, Ce3+/Ce4+ and Fe2+/Fe3+ valence state equilibrium, and oxygen defect concentration were comprehensively analyzed. The experimental results show that elevated oxygen partial pressure facilitates the generation of α-Fe2O3 impurity phases and increases lattice parameters and unit cell volume, while the oxygen-rich atmosphere stabilizes the Ce4+ and Fe3+ valence states. Appropriately increasing the pre-sintering temperature can effectively eliminate residual impurity phases, refine plate-like grain morphology and optimize crystal structure. The magnetic properties present a non-monotonic variation trend with oxygen partial pressure, increasing first and then decreasing. The optimal comprehensive magnetic properties (Ms of 60.55 emu/g-1, Br of 25.96 emu/g-1, and Hc of 1765 Oe) are obtained under the pre-sintering condition of 50% oxygen partial pressure and 1250 °C, which achieves an excellent balance of high phase purity and fine microstructure. This work provides a reliable theoretical basis and feasible process guidance for the development and performance improvement of low-cost and high-performance Ce/La mixed rare-earth co-doped strontium ferrite magnetic materials.
A titanate-octyltrimethoxysilane (OTMS) composite passivation was successfully conducted on zinc-electroplated NdFeB magnets using a single-step process. The influence of OTMS concentration in the passivation bath on the microstructure and anti-corrosion properties of the resulting film was systematically investigated. The surface and cross-sectional morphologies, phase composition, chemical states, and thickness of the coatings were characterized by cold-field emission scanning electron microscopy, X-ray diffraction, and X-ray photoelectron spectroscopy. Corrosion resistance was evaluated through static total-immersion tests, potentiodynamic polarization, electrochemical impedance spectroscopy, and accelerated aging tests. The results indicate that an optimal concentration of OTMS increases the titanium content within the passivation layer, and promotes the formation of a continuous, dense three-dimensional network structure. The optimal Zn(TO-5)/NdFeB exhibited a decreased corrosion current density from 2.302 × 10-4 A·cm-2 to 0.892 × 10-4 A·cm-2, and a positive shift in corrosion potential from –1.373 V to –1.302 V (vs. SCE). This developed tortuous network structure effectively prolongs the diffusion pathways of corrosive species, leading to a significant enhancement in the long-term corrosion protection of the NdFeB magnets.