This study is concerned with the strength limit state of serial bolted connections in structural steel plates. It points out that the ultimate load capacity of a serial bolted connection failing in combined bearing and shear-out cannot be computed as the simple sum of the respective ultimate bearing and ultimate shear-out capacities, which is implicitly permitted in design specifications worldwide. Based on the laboratory test results of 10 hot-rolled steel plate specimens composed of three different grades with nominal thicknesses ranging from 5 to 8 mm, the paper first establishes the ultimate bearing coefficient of a 20-mm bolted connection in a structural steel plate to be 3.5. Coupled with the shear-out equation previously derived, a design equation where the shear-out capacity of the downstream bolt varying quadratically with the end distance is then proposed to determine the combined bearing and shear-out capacity. The proposed equation is demonstrated through verification against independe...

This paper examines the accuracy of design equations specified in the North American, European, and Australasian codes for cold-formed steel structures in determining the ultimate tilt-bearing capacity of single-shear bolted connections without washers in flat steel sheets. It points out that all the code equations do not properly distinguish the tilt-bearing failure mode from the conventional bearing failure mode. While the latter takes place downstream of the bolt, the former takes place upstream. Unlike the conventional bearing capacity, the tilt-bearing capacity is affected by the width of the connected sheet and does not vary linearly with either the sheet thickness or the bolt diameter. Furthermore, it is not affected by material ductility. Based on the test results of 156 specimens composed of G2 and G450 sheet steels having various dimensional configurations, this paper proposes a design equation that is dimensionally consistent and that is considerably more accurate than all the code equa...