Mechanical decrystallization and water-promoted recrystallization of cellulose were studied to understand the effects of cellulose crystallinity on reaction engineering models of its acid-catalyzed hydrolysis.
A systematic and structure-agnostic method for identifying heterogeneous activity of solid acids for catalyzing cellulose hydrolysis is presented. The basis of the method is preparation of a supernatant liquid by exposing the solid acid to reaction conditions and subsequent use of the supernatant liquid as a cellulose hydrolysis catalyst to determine the effects of in situ generated homogeneous acid species. The method was applied to representative solid acid catalysts, including polymer-based, carbonaceous, inorganic, and bifunctional materials. In all cases, supernatant liquids produced from these catalysts exhibited catalytic activity for cellulose hydrolysis. Direct comparison of the activity of the solid acid catalysts and their supernatants could not provide unambiguous detection of heterogeneous catalysis. A reaction pathway kinetic model was used to evaluate potential false-negative interpretation of the supernatant liquid test and to differentiate heterogeneous from homogeneous effects on cellulose hydrolysis. Lastly, differences in the supernatant liquids obtained in the presence and absence of cellulose were evaluated to understand possibility of false-positive interpretation, using structural evidence from the used catalysts to gain a fresh understanding of reactant–catalyst interactions. While many solid acid catalysts have been proposed for cellulose hydrolysis, to our knowledge, this is the first effort to attempt to differentiate the effects of heterogeneous and homogeneous activities. The resulting supernatant liquid method should be used in all future attempts to design and develop solid acids for cellulose hydrolysis.
Low- and middle-income countries have tremendous potential for renewable energy production, including production of renewable carbon from locally prolific crops. In this work, bamboo endemic to West Africa (Bambusa vulgaris) was studied as a feedstock for the production of renewable sugars as the gateway to the local production of biofuels and bio-based chemical products. The effectiveness of delignification and amorphization pretreatments was evaluated, with the observation that quantitative (97 ± 4%) sugar yields could be obtained with a rapid initial hydrolysis rate (82 ± 4 mg g−1 h−1) but only when amorphization was performed following delignification. Experimental measurements and further characterization using 13C solid state nuclear magnetic resonance (NMR) helped establish the importance of amorphization and delignification and explained why the order of these treatments determined their effectiveness. The economics of the bamboo-based process were compared with those projected for corn stover, selected as a well-studied benchmark crop. Because of the higher bamboo growth rate compared with corn stover and the effectiveness of the pretreatment, the projected net present value (NPV) of the bamboo biorefinery was positive ($190 MM, U.S.), whereas the corn biorefinery projected to negative NPV (−$430 MM, U.S.). A socially sustainable framework for deployment of a bamboo biorefinery in a low- or middle-income economy was then proposed, guided by the principle of local ownership and stakeholder buy-in. The findings presented here motivate further investment in development of bamboo cultivation and conversion to sugars as a rapid route to decarbonization of low- and middle-income economies.