Interest in biomass has increased due to current environmental issues, and biomass analysis is usually performed using element and proximate analyses to ascertain its fuel characteristics. Mainly, element component prediction models have been developed based on proximate analysis, yet few studies have predicted proximate components based on element analysis. Hence, this study developed a proximate component prediction model following the calorific value calculation. Analysis of Pearson’s correlation coefficient showed that volatile matter (VM) and fixed carbon (FC) were positively correlated with hydrogen and oxygen, and with carbon, respectively. Thus, the model correlation was developed using a combination of the “stepwise” and “enter” methods along with linear or nonlinear regressions. The optimal models were developed for VM and ash content (Ash). The VM optimal model values were: R² = 0.9402, root-mean-square error (RMSE) = 7.0063, average absolute error (AAE) = 14.8170%, and average bias error (ABE) = −11.7862%. For Ash, the values were: R² = 0.9249, RMSE = 2.9614, AAE = 168.9028%, and ABE = 167.2849%, and for FC, the values were: R² = 9505, RMSE = 6.3214, AAE = 18.3199%, and ABE = 15.0094%. This study provides a model to predict the proximate component by element analysis. Contrary to existing method, proximate analysis can be predicted based on elemental analysis, and shows that consume samples can be performed at once.

Agricultural by-products have several disadvantages as fuel, such as low calorific values and high ash contents. To address these disadvantages, this study examined the mixing of agricultural by-products and spent coffee grounds, for use as a solid fuel, and the improvement of fuel characteristics through torrefaction. Pepper stems and spent coffee grounds were first dried to moisture contents of <15% and then combined, with mixing ratios varying from 9:1 to 6:4. Fuel pellets were produced from these mixtures using a commercial pelletiser, evaluated against various standards, and classified as grade A, B, or Bio-SRF. The optimal ratio of pepper stems to spent coffee grounds was determined to be 8:2. The pellets were torrefied to improve their fuel characteristics. Different torrefaction temperatures improved the mass yields of the pellets to between 50.87% and 88.27%. The calorific value increased from 19.9% to 26.8% at 290 °C. The optimal torrefaction temperature for coffee ground pellets was 230 °C, while for other pellets, it was 250 °C. This study provides basic information on the potential enhancement of agricultural by-products for fuel applications.

Emerging global environmental pollution issues have caused a reduction in coal utilization, leading to an increased research focus on biomass use as an alternative. However, due to the low heat values of biomass, studies in this field are still in progress. Biomass primarily comprises cellulose, hemicellulose, and lignin. To determine the composition of these three components, the measurement methods recommended by TAPPI (Technical Association of the Pulp and Paper Industry) and NREL (National Renewable Energy Laboratory) are typically employed involving equipment such as HPLC. However, these methods are time consuming. In this study, we proposed a model for predicting cellulose, hemicellulose, and lignin contents based on elemental and industrial analyses. A dataset comprising 174 samples was used to develop this model. This was validated using 25 additional samples. The R²_P values for cellulose, hemicellulose, and lignin were 0.6104–0.6362, 0.4803–0.5112, and 0.7247–0.7914, respectively; however, the R²_CV values obtained from the validation results were 0.7387–0.7837, 0.3280–0.4004, and 0.7427–0.7757, respectively. The optimal models selected for cellulose, lignin, and hemicellulose were C1, L2, and 100-(C1-L2) or H2, respectively. Our predictions for woody and herbaceous biomass, including torrefied samples, should be applied with caution to other biomass types due to the potential accuracy limitations. To enhance the prediction accuracy, future research should broaden the range of biomass types considered and gather more data specifically related to woody and herbaceous biomass.

The continued use of fossil fuels is contributing to severe environmental pollution and the establishment of an abnormal climate; consequently, alternative renewable energy sources are being actively investigated worldwide. Further, following global trends, numerous countermeasures aimed at improving carbon neutrality, promoting sustainable agriculture, and reducing fossil fuel dependence are being implemented in the Republic of Korea. Therefore, this study was conducted to investigate the application of renewable energies for greenhouse heating in the Republic of Korea. Three hybrid systems, numbered 1–3, were constructed using a pellet boiler, hydrothermal heat pump, and solar heat collection system, respectively. Thereafter, the heating performance, combined heat efficiency, energy consumption per temperature lifting, and energy cost per temperature lifting of the systems were compared. The combined thermal efficiency results showed no significant differences. However, in terms of energy consumption and cost, hybrid system 1 demonstrated 25.7 and 24.1% savings, respectively, compared with the other systems. Moreover, based on economic analysis via the net present value and life cycle cost analysis methods, the system reduced costs by 29.2 and 27.7%, respectively, compared with conventional fossil fuel boilers. Thus, hybrid system 1 was identified as the most economical system.

Wood biomass is an alternative to fossil fuels. However, biomass use has several limitations. Torrefaction, in which reduction conditions prevail to overcome these limitations, has been suggested. Here, torrefaction using different wood chips (Liriodendron tulipifera, Populus canadensis, Pinus rigida, and Pinus koraiensis) was conducted under oxygen-rich and oxygen-lean conditions to determine the effects of oxygen. Torrefaction was conducted at 230–310 °C for 1 h. A mass yield difference of 3.53–20.02% p (percentage point) was observed between oxygen-lean and oxygen-rich conditions. The calorific value increased by a maximum of 50.95% and 48.48% under oxygen-rich and oxygen-lean conditions, respectively. Decarbonization (DC), dehydrogenation (DH), and deoxygenation (DO) occurred in the following order because of dehydration and devolatilization during biomass torrefaction: DO > DH > DC. The calorific value of the torrefied biomass increased linearly with the extent of all three processes. The combustibility index and volatile ignitability were calculated based on proximate composition to suggest the optimal conditions for replacing anthracite and bituminous coal. This study provides suggestions for stable operation in a standard boiler design.

This study considers the possibility of utilizing agri-byproducts as energy sources via pelletization and torrefaction. Pellets were placed in a capsule and torrefied in an electrical furnace. Subsequently, they were cooled for 30 min, and their mass loss was measured. To investigate the resulting changes in fuel characteristics, ultimate and proximate analyses were performed, and calorific values were measured. To estimate the water absorption of the pellets, hygroscopicity evaluations were conducted. Based on the experimental results, the energy yield, lower heating value, and exergy were calculated to determine the optimum conditions for torrefaction. The calculation was performed by utilizing the useful exergy and standards applied to biomass power plants. We determined that torrefaction for agro-pellets should be conducted under low-to-intermediate temperatures (210–250 °C) within a period of 50 min. Under these conditions, 7–55% mass reductions were observed, the higher heating value increased from 4110 to 6880 kcal kg⁻¹, and the lower heating value changed from 3780 to 6520 kcal kg⁻¹ owing to reduced hygroscopicity. So, Agro-byproducts can contribute to the practical application by improving the heating value through torrefaction as an alternative to wood pellets.