It is useful to have analytic expressions for important functions in the equations of state of materials. The Debye model has been quite successful in approximating the thermal energy properties of a variety of solids, but is nonanalytic. Existing approximations suffer from various shortcomings, the most common being lack of applicability over some temperature range. A new analytic and integrable functional form that closely approximates the Debye model for the heat capacity is presented. This form, based on the mean of two Einstein heat capacity functions with a low temperature correction, exhibits deviations from the Debye model smaller than typical experimental scatter in heat capacity data.
Dynamic compression experiments in condensed matter are of interest in part because they provide opportunities to examine material response under extreme condit
1 November 2006 in Review of Scientific Instruments
By changing from the metallic foil of the Asay foil diagnostic, which can detect ejecta from a shocked surface, to a lithium fluoride (LiF) or polymethyl methacrylate (PMMA) window, it is possible to detect multiple spall layers and interlayer rubble. Past experiments to demonstrate this diagnostic have used high explosives (HEs) to shock metals to produce multiple spall layers. Because the exact characteristics of HE-induced spall layers cannot be predetermined, two issues exist in the quantitative interpretation of the data. First, to what level of fidelity is the Asay window method capable of providing quantitative information about spall layers, possibly separated by rubble, and second, contingent on the first, can an analytic technique be developed to convert the data to a meaningful description of spall from a given experiment? In this article, we address the first issue. A layered projectile fired from a gas gun was used to test the new diagnostic’s accuracy and repeatability. We impacted a LiF or PMMA window viewed by a velocity interferometer system for any reflector (VISAR) probe with a projectile consisting of four thin stainless steel disks spaced apart with either vacuum or polyethylene. The window/surface interface velocity measured with a VISAR probe was compared with calculations. The good agreement observed between the adjusted calculation and the measured data indicates that, in principle and given enough prior information, it is possible to use the Asay window data to model a density distribution from spalled material with simple hydrodynamic models and only simple adjustments to nominal predictions.
Experiments to investigate ejecta production in shocked tin have been performed using plate impact facilities at Los Alamos National Laboratory. Three primary diagnostics — piezoelectric pins, Asay foils, and low energy X‐ray radiography — were fielded simultaneously in an attempt to quantify the amount of ejecta produced in tin as the shock wave breaks out of the free surface. Results will be presented comparing and contrasting all three diagnostics methods. Advantages and disadvantages of each method will be discussed.
In our investigation of ejecta, or metal particulate emitted from a surface subjected to shock‐loaded conditions, we have developed a shock experiment suitable for testing new ideas in piezoelectric mass and impact detectors. High‐explosive (HE) shock loading of tin targets subjected to various machined and compressed finishes results in significant trends in ejecta characteristics of interest such as areal density and velocity. Our enhanced piezoelectric diagnostic, “piezo‐pins” modified for shock mitigation, have proven levels of robustness and reliability suitable for effective operation in these ejecta milieux. These field tests address questions about ejecta production from surfaces of interest; experimental results are discussed and compared with those from complementary diagnostics such as x‐ray and optical attenuation visualization techniques.
7 May 2014 in Journal of Physics: Conference Series