We report the first organic light-emitting field-effect transistor. The device structure comprises interdigitated gold source and drain electrodes on a substrate. A polycrystalline tetracene thin film is vacuum sublimated on the substrate forming the active layer of the device. Both holes and electrons are injected from the gold contacts into this layer leading to electroluminescence from the tetracene. The output characteristics, transfer characteristics, and the optical emission properties of the device are reported. A possible mechanism for electron injection is suggested.
In this study, the optical properties of nanocrystalline europium doped yttria, were investigated in dependence on different caging hosts such as porous MCM-41, porous silica, and porous alumina with pore sizes ranging between 2.7 to 80 nm. These results were compared to nanopowders measured in air and aqueous solution whose particle sizes were 5 nm and 8 nm, respectively. All these results were compared to a commercial lamp phosphor powder with a grain size of about 5 μm. The structural properties of the samples were determined by x-ray diffraction and transmission electron microscopy. Investigated optical properties are the photoluminescence emission spectra, the excitation spectra, the lifetimes, and the quantum efficiencies. A heavy dependence of the charge transfer process on the surrounding will be reported and discussed.
The mechanisms of enhanced electron injection into the electron transport layer of [tris(8-hydroxyquinoline)-aluminum] via LiF interlayers are studied by means of characteristics, secondary ion mass spectroscopy (SIMS), and Kelvin probe measurements. Devices for single carrier injection were prepared using aluminum electrodes, electron transport layers, and thin intermediate layers of LiF. It was found that devices deposited in the order -LiF-aluminum have a much higher electron injection capability than structures deposited in the order aluminum-LiF- SIMS depth profile analysis reveals that the evaporation of Al on LiF leads to a spatial separation of Li and F probably induced by a chemical reaction of Al with LiF. Simple thermodynamic calculations support the energetic feasibility of such a reaction. Titanium cathodes in the same layer sequence also exhibit electron injection enhancement, probably due to their similar chemical reactivity. However, electron injection from Ag electrodes is not significantly improved by the introduction of a LiF interlayer.