A cyclone separator holds significant importance as the primary gas–solid separation apparatus in the industrial sector. Cyclone separators operate based on a fundamental principle, primarily harnessing the centrifugal force produced by the rotation of air in order to segregate solid particles from the gas stream and then collect them. In addition to the main vortex in the flow field, there are a number of secondary flows, which significantly impact the aggregation of fine particles and contribute to the heightened energy consumption. This paper provides a summary of the three secondary flows in a cyclone separator. These include the recirculation flow in the annular space, which is greatly influenced by the inlet particle concentration. Additionally, the short-circuit flow occurs beneath the vortex finder as a result of the collision between the incoming flow and the rotating flow. Furthermore, the eccentric circumfluence is defined as the deviation of the rotation center caused by the interaction between the upward and downward flows near the discharge. This paper aims to establish a theoretical framework to investigate the flow pattern tracking and the mitigation of secondary flows in order to enhance the operational efficiency of cyclone separators.
1 September 2026 in Journal of Resources and Ecology
This study utilizes the k-ε model to investigate the effects of complex urban structures on surrounding airflow and pollutant dispersion under different Richardson numbers (Rib). The wind tunnel experimental data used for model validation were obtained from an open-source dataset provided by the Architectural Institute of Japan (AIJ). The results demonstrate that numerical simulation effectively captures the effects of idealized urban arrays on airflow patterns and pollutant dispersion. The simulation results are consistent with those obtained from wind tunnel experiments (WTE) performed under similar conditions, thereby validating the numerical approach. The longitudinal velocity (u/uH) shows significant variation near the center of street canyons. Moreover, changes in u/uH are more pronounced on the leeward side (LS) of the building compared to the windward side (WS). When Rib exceeds 0.25, the stagnation point and vortex center on the WS of the buildings gradually move upward. Meanwhile, the vortex within the street canyons near the center of the block starts to dissipate. The length of the recirculation zone on the LS of the block decreases from x/H=15.0 to x/H=13.0, whereas the longitudinal influence range of the block expands from y/H=±9.0 to y/H=±12.0. The highest normalized turbulence kinetic energy (TKE/uH2) is observed at the WS corner of the building and diminishes as the Rib increases. Under stable stratification, increasing Rib suppresses vertical pollutant transport while enhancing horizontal spreading. Consequently, the height of high-concentration areas gradually decreases, causing pollutant accumulation within the neighborhoods and hindering pollutant dispersion.