Paula Wahlgren

Paula Wahlgren

orcid

Research Focus & Metrics

Academic Career Length

32Years (1995-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 May 1998 in Science
Verified
Journal Article
Closed access
PDF file
RSR. J. Schoelkopf
R. J. Schoelkopf
PWPaula Wahlgren
Paula Wahlgren
AKA. A. Kozhevnikov
A. A. Kozhevnikov
PDP. Delsing
P. Delsing
DPD. E. Prober
D. E. Prober
A new type of electrometer is described that uses a single-electron transistor (SET) and that allows large operating speeds and extremely high charge sensitivity. The SET readout was accomplished by measuring the damping of a 1.7-gigahertz resonant circuit in which the device is embedded, and in some ways is the electrostatic “dual” of the well-known radio-frequency superconducting quantum interference device. The device is more than two orders of magnitude faster than previous single-electron devices, with a constant gain from dc to greater than 100 megahertz. For a still-unoptimized device, a charge sensitivity of 1.2 × 10 −5 e / hertz was obtained at a frequency of 1.1 megahertz, which is about an order of magnitude better than a typical, 1/ f -noise-limited SET, and corresponds to an energy sensitivity (in joules per hertz) of about 41 ℏ︀.

15 July 1995 in Physical Review B
Verified
Journal Article
Closed access
PDF file
PWPaula Wahlgren
Paula Wahlgren
PDP. Delsing
P. Delsing
DHD. B. Haviland
D. B. Haviland
We have investigated several single and double aluminum tunnel junctions in the nonsuperconducting state. Current-voltage (I-V) characteristics were measured up to voltages corresponding to several hundred times e/C, where C is the capacitance of each junction. The individual junctions had capacitances in the order of 0.5 fF and resistances of 50–150 kΩ. The offset voltage, defined as Voff=V-I/(dI/dV), is resistance independent for given junction capacitances, but depends on the bias voltage. For a single junction the offset voltage is very small for low voltages, but it approaches the local-rule value of e/2C at high voltages. For a double junction the global rule applies at low voltages and the offset voltage equals Voff=e/CΣ, where CΣ=2C+C0. At large voltages the local rule applies and each junction contributes with a voltage of e/2C to the offset voltage, so that Voff=e/C. This paper shows that a careful analysis of the offset voltage has to be made to determine the values of the capacitances involved.

1 November 2015 in Energy Procedia
Verified
Journal Article
Open access
ABAxel Berge
Axel Berge
CHCarl-Eric Hagentoft
Carl-Eric Hagentoft
PWPaula Wahlgren
Paula Wahlgren
BABijan Adl-Zarrabi
Bijan Adl-Zarrabi
A variable U-value would be beneficial for a buildings thermal performance. One way to switch the U-value of a wall, insulated with nano-porous material, is to change the internal pressure of the insulation This paper present thermal conductivity measurements showing a possible variation around of 3 times for a fumed silica and less than 2 times for an aerogel blanket when the pressure was varied between 1 and 100kPa. The variation factor of 3 was used in building energy simulation of a Swedish office showing that a U-value which can be varied within that range can give a significant reduction energy demand. Especially when energy used for cooling is weighted as worse than energy used for heating

15 January 1998 in Physical Review B
Verified
Journal Article
Closed access
PDF file
PWPaula Wahlgren
Paula Wahlgren
PDP. Delsing
P. Delsing
TCT. Claeson
T. Claeson
DHD. B. Haviland
D. B. Haviland
The effect of the electromagnetic environment on Coulomb blockade devices can be estimated through a simple horizon model where the interaction length is determined by the Heisenberg uncertainty principle. The advantage of this horizon model can be demonstrated in a device with two tunnel junctions in parallel where a cutoff voltage related to physical dimensions is observed. This model also explains the characteristics of single junctions and single-electron tunneling (SET) transistors. Several Al/AlOx/Al devices of various geometries were measured and the effective Coulomb barrier has been investigated through the offset voltage defined as Voff≡V−IdV/dI. We have also used Voff to determine the capacitances of SET transistors, from which we determined microstrip capacitance as a function of island size.

16 December 2002 in Applied Physics Letters
Verified
Journal Article
Closed access
KSK. Segall
K. Segall
KLK. W. Lehnert
K. W. Lehnert
TST. R. Stevenson
T. R. Stevenson
RSR. J. Schoelkopf
R. J. Schoelkopf
PWPaula Wahlgren
Paula Wahlgren
PDP. Delsing
P. Delsing
We demonstrate a high-performance cryogenic amplifier based on a radio-frequency single-electron- transistor (rf-SET). The high charge sensitivity and large bandwidth of the rf-SET, along with low power dissipation, low capacitance and on-chip integrability, make it a good candidate for a general-purpose cryogenic amplifier for high impedance sources. We measure a large-gate rf-SET with an open-loop voltage noise of 30 nV/(Hz), among the lowest reported voltage noise figures for a SET. Using a closed-loop transimpedance configuration, the amplifier shows almost 2 orders of magnitude increase in dynamic range, a 3 dB bandwidth of 30 kHz, and a transimpedance gain of 50 V/μA for a cryogenic 1 MΩ load resistor. The performance of this amplifier is already sufficient for use as an integrated readout with some types of high-performance cryogenic detectors for astrophysics.

19 October 2021 in Heritage
Verified
Journal Article
Open access
PDF file
AJAdeline Jerome
Adeline Jerome
PFPaula Femenias
Paula Femenias
Liane ThuvanderLiane Thuvander
Liane Thuvander
PWPaula Wahlgren
Paula Wahlgren
PJPär Johansson
Pär Johansson
Cultural value and heritage have been identified as necessary for a sustainable living environment, alongside environmental concern and energy efficiency. In this study, multiple methods, i.e., life cycle assessment, payback, and questionnaires and interviews with tenants, and empirical data from a recent energy renovation of a multi-residential pre-war building with wooden construction were used to analyse the impact of the renovation on cultural and aesthetic values, environmental impact, financial payback time, and user satisfaction. In the energy renovation, the façade, which had been disfigured in an earlier renovation, was recreated to resemble the original architecture. The main questions are: What impact has the recreation of the façade on the environmental payback time in comparison to a more conventional renovation? What are the consequences for the user satisfaction and financial return on investment? The results show that the recreated façade has improved the building’s aesthetics without compromising the environmental benefits. It also resulted in better thermal comfort, which is highly valued by the tenants. The improved aesthetics are also appreciated by the tenants, but to a lesser extent. Financially, the renovation is estimated to be not viable. Results of this study can be applied in the decision-making of similar renovation projects.