Emissions from heavy-duty vehicles need to be reduced to decrease their impact on the climate and to meet future regulatory requirements. The use of a cost-optimized thermoelectric generator based on total cost of ownership is proposed for this vehicle class with natural gas engines. A holistic model environment is presented that includes all vehicle interactions. Simultaneous optimization of the heat exchanger and thermoelectric modules is required to enable high system efficiency. A generator design combining high electrical power (peak power of about 3000 W) with low negative effects was selected as a result. Numerical CFD and segmented high-temperature thermoelectric modules are used. For the first time, the possibility of an economical use of the system in the amortization period of significantly less than 2 years is available, with a fuel reduction in a conventional vehicle topology of already up to 2.8%. A significant improvement in technology maturity was achieved, and the power density of the system was significantly improved to 298 W/kg and 568 W/dm3 compared to the state of the art. A functional model successfully validated the simulation results with an average deviation of less than 6%. An electrical output power of up to 2700 W was measured.
5 February 2020 in Journal of Electronic Materials
Current research has led to a significant improvement at the system level of thermoelectric generators (TEG) for automotive applications. The previously low power density could be increased considerably up to 267 W/kg and 478 W/dm3. In addition, the cost–benefit ratio of the technology in the overall system of the vehicle was improved through intensive optimizations on system level. The results presented so far are based on measurement data of single thermoelectric modules (TEM) and simulation of the TEG system. In this paper the high simulative increases at the system level, achieved through a holistic optimization method, are validated by a functional prototype, completely equipped with TEM. Thereby, a functional prototype has been developed and built successfully and measured on a hot gas test bench. In the experiment all TEM show a stable power output and the highest gravimetric power density of automotive TEG systems known to the authors could be measured. Further tests will be performed with the functional prototype as described in the outlook. In addition to the successful tests, the simulation is validated with the detailed measurement data. After adapting the measurement method of the TEM for providing more accurate TEM measurement data as input for the simulation, a suitable match could be achieved between the TEG simulation and the experiment. In the measurement points performed so far, the accuracy of the simulated temperatures reaches more than 95%. The accuracy of the simulated output power is more than 97%.
This paper presents a thermoelectric generator (TEG) as a waste heat recovery system (WHRS) for commercial vehicles (CVs), for light, medium and heavy duty. An analysis of the potential and a close investigation of the limitations are given. The use of this system in future in combination with diesel, dual fuel, or gas combustion engines and in hybrid powertrains is discussed as a promising solution to increase vehicle efficiency.
1 September 2016 in Journal of Physics: Conference Series
This paper presents a numerical model for a thermoelectric generator (TEG) on the tailpipe of commercial (3.5-ton) and heavy duty (40-ton) vehicles. The widths and lengths of the TEG for the two vehicles are 0.10 m × 0.15 m and 0.2 m × 0.15 m respectively. Exhaust gas is used as the heat source and cooling water is the heat sink. Both fluids flow in the same direction. The study examines the improvement in heat transfer from the exhaust gas side. A numerical model is developed that provides a choice between two different heat exchanger configurations with either plain fins or offset strip fins. The influence of fin height, length and spacing is analysed. According to the criteria used in this study, plain fins are a better choice, yielding a maximum electrical power of 107 W for the commercial vehicle and 480 W for the heavy duty vehicle.