Gas–liquid flow in a pipeline is a very common. Slug two-phase flow is dominated in the case of slightly upward flow (+0.25°) and considered to be the comprehensive flow configuration, and can be in close contact with all the other flow patterns. The models of different flow patterns can be unified. Precise prediction of the slug flow is crucial for proper design and operation. In this paper, we develop hydrodynamics unified modeling for gas–liquid two-phase slug flow, and the bubble and droplet entrainment is optimized. For the important parameters (wall and interfacial friction factors, slug translational velocity and average slug length), the correlations of these parameters are optimized. Furthermore, the related parameters for liquid droplet and gas bubble entrainment are given. Accounting for the gas–liquid interface shape, hydrodynamics models, i.e., the flat interface model (FIM) and the double interface model (DIM), of liquid film in the slug body are applied and compared with the experimental data. The calculated results show that the predictions for the liquid holdup and pressure gradient of the DIM agree with experimental data better than those of the FIM. A comparison between the available experimental results and Zhang’s model calculations shows that the DIM model correctly describes the slug dynamics in gas–liquid pipe flow.

Wax precipitation and deposition are serious flow assurance problems. Wax precipitation is investigated simultaneously using centrifugation and high-temperature gas chromatography (C-HTGC) to obtain the amount and component distribution of precipitated wax in artificial waxy oil and diesel at different temperatures. However, the conventional C-HTGC method gives upper measurements of the amount of precipitated wax, as it ignores wax dissolved in crude oil in the centrifugal cake. A modified C-HTGC method was developed to obtain the precipitated solid fraction of crude oil, based on the mass balances of the non-crystallized fraction of the centrifuged cake. The weight, percent and carbon number distribution of precipitated solid wax crystals at different temperatures of artificial oil and 0# diesel were obtained. It was found that wax precipitation characteristics are affected by many factors, including the carbon number distribution of the oil, the sensitivity of alkane crystallization to temperature and the temperature of the waxy oil solution. The average carbon number of alkanes in precipitated wax crystals decreases with the decrease in temperature. The distribution of alkanes in solid wax crystals is roughly the same as that in 0# diesel but slightly heavier than in diesel. Alkanes with high carbon numbers precipitate simultaneously with those with low carbon numbers.