This paper presents a broadband GaN pseudo high-electron-mobility transistor (pHEMT) two-stage driver amplifier based on an enhanced feedback technique for a wideband system. Through well-designed parameter values of the feedback and the matching structure of the circuit, a relatively flat frequency response was obtained over a wide frequency band. Simultaneously, in order to reduce the fluctuation of current caused by the environmental temperature, a bias circuit with quiescent current temperature compensation was designed. The driver power amplifier, which was implemented in the form of a monolithic microwave integrated circuit (MMIC), was designed to drive a broadband high-power amplifier. The designed broadband driver amplifier for the 6 GHz to 20 GHz frequency band had a very small die size of 1.5 × 1.2 mm${}^2$ due to the use of an optimized impedance matching structure. It exhibited a small-signal gain of 12.5 dB and output power of 26 dBm. The flatness of this driver amplifier for gain and output power was achieved as ±2.5 dB and ±1 dB over the entire frequency band, respectively. The experimental results showed up to 35 dBm in the OIP3, and the current variation range was ±5 mA after using the temperature compensation bias circuit.

This paper proposes a 110% relative bandwidth (RBW) low-noise amplifier (LNA) for broadband receivers with flat gain, low noise and high linearity. Bias and parasitic parameters derived wide bandpass (BPDWB) matching networks and a cascode with dual feedbacks are introduced for broadband performance. Matching network design procedures are demonstrated, and results show that the frequency response of the network fits the target impedance well from 1 GHz to 3.5 GHz. The proposed BPDWB network improves the design efficiency and enhances the prediction accuracy of impedance matching. The proposed LNA in 0.25 μm GaAs pseudomorphic high electron mobility transistor (GaAs pHEMT) technology realizes a minimum NF of 0.45 dB at 1.6 GHz where the NF is less than 0.55 dB within the operating frequency band. A flat gain of 22.5–25.2 dB is achieved with the input voltage standing wave ratio (VSWR) below 1.22 and output VSWR less than 2.5. In addition, the proposed LNA has good linearity where the output third-order intercept point (OIP3) is better than +31.5 dBm, and the output 1 dB compression point (OP1dB) is better than +19 dBm over the wide frequency range.

In this paper, a methodology for designing a distributed model for coplanar asymmetry transformer on gallium nitride (GaN) process is proposed, which can accurately characterize the transformer’s feature up to a millimeter-wave band. The paper analyses a transformer-based matching circuit and proposes a practical transformer design procedure. A two stage, transformer matching based X-band power amplifier (PA) is reported here. Using the proposed transformer model and correlated transformer design procedure can sharply reduce schematic design period and optimum process time. The PA chip is designed on a 0.25 µm GaN technology process and occupies a 1.515 mm² area. At a 28 V supply, the gain and output power of the PA reaches 15 dB and 29 dBm respectively, and the wideband matching transformer reaches 47.6% bandwidth. To the best of our knowledge, the distributed model for coplanar asymmetry transformer and transformer-based X-band MMIC PA on GaN process in this work is the first case among the reported papers.