Molybdenum trioxide is an abundant natural, low-cost, and environmentally friendly material that has gained considerable attention from many researchers in a variety of high-impact applications. It is an attractive inorganic oxide that has been widely studied because of its layered structure, which results in intercalation ability through tetrahedral/octahedral holes and extension channels and leads to superior charge transfer. Shape-related properties such as high specific capacities, the presence of exposed active sites on the oxygen-rich structure, and its natural tendency to oxygen vacancy that leads to a high ionic conductivity are also attractive to technological applications. Due to its chemistry with multiple valence states, high thermal and chemical stability, high reduction potential, and electrochemical activity, many studies have focused on the development of molybdenum oxide-based systems in the last few years. Thus, this article aims to briefly review the latest advances in technological applications of MoO₃ and MoO₃-based materials in gas sensors, lithium-ion batteries, and water pollution treatment using adsorption and photocatalysis techniques, presenting the most relevant and new information on heterostructures, metal doping, and non-stoichiometric MoO_3−x.

The physical properties of porous silica nanofibers are an important factor that impacts their performance in various applications. In this study, porous silica nanofibers were produced via solution blow spinning (SBS) from a silica precursor/polymer solution. Two polyvinylpyrrolidone (PVP, M_w = 360,000 and 1,300,000) were chosen as spinning aids in order to create different pore properties. The effect of their physical properties on the adsorption of methylene blue (MB) in an aqueous solution was explored. After forming, the nanofibers were calcined to remove the organic phase and create pores. The calcined nanofibers had a large amount of micro and mesopores without the use of additional surfactants. The molecular weight of the PVP impacted the growth of silica particles and consequently the pore size. High M_w PVP inhibited the growth of silica particles, resulting in a large volume of micropores. On the other hand, silica nanofibers with a high fraction of mesopores were obtained using the lower M_w PVP. These results demonstrate a simple method of producing blow spun silica nanofibers with defined variations of pore sizes by varying only the molecular weight of the PVP. In the adsorption process, the accessible mesopores improved the adsorption performance of large MB molecules.