Foundation piles transfer the applied vertical load to the surrounding soil by skin friction and base resistance. These two components induce stress in the soil. The load transfer is still not fully recognized, and some pile load tests analyses have raised many doubts. The present paper aimed to measure the stress levels during pile load tests in laboratory conditions. This research examined the possibilities of using thin, flexible sensors in measuring the stress in soil. Two sensors were used: tactile pressure sensor with mapping system and color film pressure sensors with digital analyzing. Calibration and preliminary tests of the sensors have been described. This calibration proved that this kind of sensor could measure the stress in the soil in laboratory conditions. The results of stress distribution in the soil, shown as pressure maps, have been presented. Significant stress changes were observed in pile load tests. Rough and smooth piles were compared in the analyses. Stress distribution was the result of simultaneous interaction of pile skin and base. The knowledge about stresses surrounding the pile allows us to carry out a deeper analysis of the pile–soil interaction.
Bicycle road infrastructure on weak or organic subgrades requires ground improvement or foundation solutions that vary significantly in material demand and construction complexity, yet their environmental implications remain poorly understood. This study applies a cradle-to-grave life cycle assessment (LCA), conducted in accordance with ISO 14040/44 and EN 15804+A2 using the Environmental Footprint (EF) 3.1 method, to compare three asphalt bicycle road designs differing solely in their substructure and foundation approach: a lightweight EPS geofoam embankment (Design 1), conventional non-cohesive soil replacement (Design 2), and a CFA micropiles system with a geogrid-reinforced working platform (Design 3). Ten midpoint impact categories were evaluated over a 15-year service life per 1 km of pavement. Results reveal that the choice of foundation solution is the decisive factor in environmental performance, with Design 1 achieving the lowest impacts across all ten indicators, followed by Design 3, and Design 2 performing worst despite being the most conventional approach. The environmental penalty of soil replacement stems from the disproportionate mass of embankment fill required (≈67,839 t versus ≈3955 t for the geofoam alternative), which amplifies burdens across material production, construction machinery use, and end-of-life processing. For the pile-based design, long-distance multimodal transport of imported aggregate dominates the impact profile, contributing over 54% of total GWP. This finding indicates that the environmental performance of the pile-supported alternative is highly sensitive to material sourcing and could be significantly improved through the use of locally available aggregates. The use and maintenance stage contributes identically and negligibly across all three designs, confirming that observed differences originate exclusively from substructure and foundation-related material flows. These findings demonstrate that substituting large soil volumes with lightweight engineered materials in pavement foundation design can deliver substantial environmental benefits without compromising structural function, offering a quantitative basis for integrating environmental criteria into foundation selection for cycling infrastructure on problematic subgrades.