Cyclic hollow cylinder torsional tests were performed in undrained conditions on 12 compacted clay specimens collected from two types of dams (an earth-core rock-filled dam and an earth-zone dam) in Thailand. The cyclic degradation, cyclic pore water pressure generation, and volumetric cyclic threshold shear strain were studied via multistage strain-controlled tests. The testing program encompassed five overconsolidation ratios (OCRs), 1, 1.5, 2, 3.5, and 4, where six to eight cyclic strain-controlled stages were applied in each test with frequency f=2 Hz. The results reveal that the volumetric threshold shear strain amplitude of these compacted clays ranged between approximately 0.009 and 0.025% and generally increased substantially with the plasticity index (PI). The cyclic pore water pressures normalized by σc′ are consistently lower than previous ones using other types of clays tested with other types of devices at comparable cyclic shear strain amplitudes. The cyclic degradation and cyclic p...

This research aims to propose the use of spectral analysis of surface wave (SASW) tests along with in-situ suction measurements for non-destructive determination of shrinkage cracks. The underlying principle behind this proposed method is that, while suction and the small-strain shear modulus are positively correlated for intact samples, this is not the case for cracked ground. A series of SASW tests were performed on a clay embankment at different periods, during which the suction, modulus, and shrinkage crack depth varied seasonally. The soil water retention curve (SWRC) of the undisturbed sample collected from the cracked zone was determined, which related the suction-to-moisture content and void ratio of the soil. A free-free resonant frequency (FFR) test in the lab was conducted to determine the small-strain shear modulus (G₀) at various moisture contents. The small-strain moduli from the SASW tests on the intact ground were generally higher than those from the FFR tests due to the effect of confining stress. A drop in the small-strain modulus determined using the SASW test was observed as an increase in suction-induced cracks and it relieved the horizontal stress. The crack depth measured in the field was then modelled using a semi-empirical procedure that can be used to predict crack depth relative to suction.

The paper presents the case study of the recurrent slope movement in colluvium deposits at Doi Chang, Thailand. A thorough site investigation confirmed the slope movement rate corresponding to slow creep during dry season, while in the rainy season, its velocity remarkably increased. Despite frequent repair, the movement rate was sufficient to result in the recurrent damage of infrastructures like roads and buildings, causing economic loss and public concerns. Furthermore, surface mapping revealed that the hill's topography led to the concentration of flowing water in a particular area. This resulted in a high level of groundwater table, especially during the rainy season. The inclinometer installed in that area suggested an average movement rate of 20.5 mm/month in the wet season. In contrast, during the dry season, it was limited within 2 mm/month, indicating that the increase in the rate of slope movement in the colluvium deposit was primarily due to the rising groundwater table. Field and laboratory tests were conducted to determine the properties of the colluvium deposit. Landslide susceptibility assessment was performed using infinite slope model and later integrated with GIS to evaluate the factor of safety (FS) over a large area. The FS decreased below 1 when the groundwater level rose to 0.3 cm below the ground surface, and using GIS, based on infinite slope model, the potential risk zone were delineated.

This paper interprets the results from field monitoring which was carried out during vacuum-PVD improvement in a site located near an actively moving slope. Interestingly, the monitoring results showed, among other things, mitigation in the outward lateral movements during and after the preloading process indicating relative stability in the slope and the efficiency of vacuum to mitigate lateral movements during the preloading period. Analyses were made on other field parameters such as pore pressure and settlement, as well as back-calculation of flow parameters to be considered during vacuum preloading design, such as permeability ratio (k_h/k_s) and horizontal consolidation coefficient (C_h) due to vacuum-PVD, were carried out. Post improvement, appropriate geotechnical properties were obtained from laboratory tests of clay specimens from borehole samples and undrained shear strengths were measured from unconfined compression and field vane shear test. The obtained properties indicated improvement in soft soil properties with a reduction in water content and an increase in maximum past pressure, OCR and undrained shear strengths. The prediction made for final shear strength using past literature, where applied additional incremental stress was reduced with depth, matched well with the shear strengths recorded from field testing.

In Bangkok, the demand for housing is extensively high due to the city growing rapidly, so some swampy areas are filled with soil. A Prefabricated Vertical Drain (PVD) with the Vacuum Consolidation Method (VCM) is required to make the soil applicable for construction. However, it is difficult to monitor the soil strength during the process because the airtight sheet will be broken. This research aims to study the possibility of using the Spectral Analysis of Surface Waves (SASW) test to monitor the effectiveness of the VCM method and to study the development of shear-wave velocity over the consolidation period. Multiple instruments were installed on site, namely, vacuum gauges, settlement plates, and a piezometer, as well as a borehole to monitor the pump pressure, settlement, porewater pressure, and soil properties. Ten SASW tests were taken to measure the change in shear-wave velocity (Vs) over 7 months. The results showed an increment in the Vs along with increments in the settlement and undrained shear strength (Su), as well as a decrement in pore pressure during the consolidation period. The correlation between Vs and soil settlement was developed to predict the amount of settlement using Vs. These all indicated the potential of using the SASW method for soil improvement monitoring purposes.