Anthropogenic activities have a significant influence on land use and land cover (LULC) changes, especially in rapidly growing areas. Among several models, the combination of a cellular automata–artificial neural network (CA-ANN) model is being widely used for assessing future LULC changes using satellite images. This study aimed to investigate LULC changes in Gazipur City Corporation (GCC), Bangladesh, and the changes in LULC patterns over the last two decades (2002 to 2022). In this study, the maximum likelihood supervised classification technique was used for processing the available satellite images. The results show that the urban area and vegetation coverage increased by 150% and 22.78%, whereas the bare land and waterbody decreased by 7.02% and 78.9%, respectively, from 2002 to 2022 inside the GCC area. For future LULC predictions, the CA-ANN model was developed, the accuracy percentage of which was 86.49%, and the kappa value was 0.83. The future LULC prediction model results show that the urban area will increase by 47.61%, whereas the bare land and waterbody are supposed to decrease by 24.17% and 67.23%, respectively, by 2042. The findings of this study could be useful for future sustainable urban planning and management, as well as enabling decision making by authorities for improvements in environmental and ecological conditions in the study area.
24 October 2017 in Earth Surface Processes and Landforms
The jet test device has been predominantly used for in situ critical shear stress (τc) and erodibility coefficient (kd) measurements of cohesive streambanks/beds using three analytical procedures: the Blaisdell method (BM), the iterative approach (IP), and the scour depth approach (SDP). Existing studies have reported that τc and kd estimates can be influenced by the computational procedure, time intervals for scour-hole depth measurements, and the pressure head selection. This study compared estimates of τc and kd among the three computational procedures using single and multiple pressure settings (SPS, MPS). A new method is introduced applying incrementally increasing pressure heads, hypothesizing depth-averaged erodibility parameters would be generated that better represent bank and fluvial erosion. Estimates of τc applying the MPS-BM procedure were greater by 17% to 100% compared with SPS-BM procedures and kd estimates were lower with less variability (σ = 3.54) compared with other procedures from 126 jet tests among 21 Tennessee stream sites. This finding supports the hypothesis of increasing τc and decreasing kd with greater soil depths into the bank, suggesting the MPS-BM procedure can improve the estimation of τc and kd using the mini-jet test device. Overall, this study demonstrates the need to standardize field and computational procedures.
Scour evolution and propagation around a cylinder in natural cohesive sediment was uniquely investigated under multi-flow event varying sequentially by velocity magnitudes. This flume study differs from others that only used test sediment with commercially available clays for single flow. The objective of this study was to explore the potential differences in scour hole development in natural riverbed sediments subjected to varying flow velocity scenarios, advancing our understanding from existing studies on scour. The study consisted of 18 experimental runs based on: velocity, flow duration, and soil bulk density. Scour hole development progressed initially along the cylinder sides, and maximum depths also occurred at these lateral locations. Scour hole depths were less for higher soil bulk densities (≥1.81 g/cm3) compared with lower densities, and erosion rates were slower. It was observed with all flow sequences that scour depths were similar at the end of each experimental run. However, scour initiation was observed to be time dependent for soils with higher bulk density (1.81–2.04 g/cm3) regardless of flow velocity sequences. The observed time dependency suggests a process feedback with the scour hole development initiated at the cylinder sides, which influence local 3D hydraulics as the scour hole depth progresses.
1 January 2022 in Journal of Hydraulic Engineering
Several methods have been developed to estimate critical shear stress and the erodibility coefficient for cohesive stream banks/beds. This research compares estimates of these parameters between an in situ minijet device and a laboratory pressurized conduit flume. Estimates for between the two devices for the same soils were in general agreement compared with , especially for shear magnitudes greater than 5 Pa and consolidated soil with moisture contents greater than 20%. However, erodibility estimates between devices were significantly different. Operation of the minijet device applied a unique multiple-pressure setting (MPS) procedure that accounts for the change in soil properties with depth from the bank face. Both the minijet MPS approach and a conduit flume appeared to reduce the effect of surface subaerial process on erodibility parameter measurements, where and estimates were more similar compared with single-pressure test estimates using the Blaisdell, iterative solution, and scour depth solution computational procedures. Findings suggest and estimates are dependent on the device hydraulics, computational method, and soil properties.
16 February 2024 in Transportation Research Record: Journal of the Transportation Research Board
Streambed scour in cohesive sediment is complex because erosion processes depend on the physical, geochemical, and biological properties of the sediment. The scouring processes can also be characterized as a slow fatigue phenomenon. Therefore, repetitive hydraulic loadings from multiple stormflow events are likely necessary for equilibrium scour depths to develop in cohesive sediment compared with non-cohesive sediment. Cumulative effective stream power, which is a surrogate measure of effective stream power duration, showed a significant relation with scour development and propagation in cohesive sediments around bridge piers, where results from this study identified a statistically significant correlation between cumulative effective stream power and the observed scour depths around different bridge piers ( R2 = 0.56, p < 0.001). However, some localized and site-specific variations were observed. It was also observed that scour depth development in cohesive soil appeared to be dependent on effective shear duration, rather than the number of flow events above erosion threshold values. In addition, the relationship between an erodibility index ( K) and critical stream power showed a significant statistical correlation ( R2 = 0.61, p = 0.017). Results from this study deviated from the Annandale empirical relationship for sediments when K < 0.1. This finding supports that site-specific critical stream power should be measured using an empirical relationship for cohesive bed sediments to predict scour depths.