Yushan Zhou

Dr. Yushan Zhou


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 August 2022 in Remote Sensing
Verified
Journal Article
Open access
PDF file
SRShanshan Ren
Shanshan Ren
XLXin Li
Xin Li
YWYingzheng Wang
Yingzheng Wang
DZDonghai Zheng
Donghai Zheng
DJDecai Jiang
Decai Jiang
YZYushan Zhou
Yushan Zhou
Due to climate warming, the glaciers of the Tibetan Plateau have experienced rapid mass loss and the patterns of glacier changes have exhibited high spatiotemporal heterogeneity, especially in interior areas. As the largest ice field within the Tibetan Plateau, the Puruogangri Ice Field has attracted a lot of attention from the scientific community. However, relevant studies that are based on satellite data have mainly focused on a few periods from 2000–2016. Long-term and multiperiod observations remain to be conducted. To this end, we estimated the changes in the glacier area and mass balance of the Puruogangri Ice Field over five subperiods between 1975 and 2021, based on multisource remote sensing data. Specifically, we employed KH-9 and Landsat images to estimate the area change from 1975 to 2021 using the band ratio method. Subsequently, based on KH-9 DEM, SRTM DEM, Copernicus DEM and ZY-3 DEM data, we evaluated the glacier elevation changes and mass balance over five subperiods during 1975–2021. The results showed that the total glacier area decreased from 427.44 ± 12.43 km2 to 387.87 ± 11.02 km2 from 1975 to 2021, with a decrease rate of 0.86 km2 a−1. The rate of area change at a decade timescale was −0.74 km2 a−1 (2000–2012) and −1.00 km2 a−1 (2012–2021). Furthermore, the rates at a multiyear timescale were −1.23 km2 a−1, −1.83 km2 a−1 and −0.42 km2 a−1 for 2012–2015, 2015–2017 and 2017–2021, respectively. In terms of the glacier mass balance, the region-wide results at a two-decade timescale were −0.23 ± 0.02 m w.e. a−1 for 1975–2000 and −0.29 ± 0.02 m w.e. a−1 for 2000–2021, indicating a sustained and relatively stable mass loss over the past nearly five decades. After 2000, the loss rate at a decade timescale was −0.04 ± 0.01 m w.e. a−1 for 2000–2012 and −0.17 ± 0.01 m w.e. a−1 for 2012–2021, indicating an increasing loss rate over recent decades. It was further found that the mass loss rate was −0.12 ± 0.02 m w.e. a−1 for 2012–2015, −0.03 ± 0.01 m w.e. a−1 for 2015–2017 and −0.40 ± 0.03 m w.e. a−1 for 2017–2021. These results indicated that a significant portion of the glacier mass loss mainly occurred after 2017. According to our analysis of the meteorological measurements in nearby regions, the trends of precipitation and the average annual air temperature both increased. Combining these findings with the results of the glacier changes implied that the glacier changes seemed to be more sensitive to temperature increase in this region. Overall, our results improved our understanding of the status of glacier changes and their reaction to climate change in the central Tibetan Plateau.

17 October 2024 in Remote Sensing of Environment
Verified
Journal Article
Closed access
YWYingzheng Wang
Yingzheng Wang
DZDonghai Zheng
Donghai Zheng
YZYushan Zhou
Yushan Zhou
YNYanyun Nian
Yanyun Nian
SRShanshan Ren
Shanshan Ren
XLXin Li
Xin Li

17 December 2021 in Remote Sensing
Verified
Journal Article
Open access
PDF file
HWHuiqiang Wang
Huiqiang Wang
YZYushan Zhou
Yushan Zhou
HFHaiqiang Fu
Haiqiang Fu
JZJianjun Zhu
Jianjun Zhu
YYYanan Yu
Yanan Yu
SHShouzhong Hu
Shouzhong Hu
The TerraSAR-X add-on for Digital Elevation Measurements (TanDEM-X) bistatic system provides high-resolution and high-quality interferometric data for global topographic measurement. Since the twin TanDEM-X satellites fly in a close helix formation, they can acquire approximately simultaneous synthetic aperture radar (SAR) images, so that temporal decorrelation and atmospheric delay can be ignored. Consequently, the orbital error becomes the most significant error limiting high-resolution SAR interferometry (InSAR) applications, such as the high-precision digital elevation model (DEM) reconstruction, subway and highway deformation monitoring, landslide monitoring and sub-canopy topography inversion. For rugged mountainous areas, in particular, it is difficult to estimate and correct the orbital phase error in TanDEM-X bistatic InSAR. Based on the rigorous InSAR geometric relationship, the orbital phase error can be attributed to the baseline errors (BEs) after fixing the positions of the master SAR sensor and the targets on the ground surface. For the constraint of the targets at a study scene, the freely released TanDEM-X DEM can be used, due to its consistency with the TanDEM-X bistatic InSAR-measured height. As a result, a parameterized model for the orbital phase error estimation is proposed in this paper. In high-resolution and high-precision TanDEM-X bistatic InSAR processing, due to the limited precision of the navigation systems and the uneven baseline changes caused by the helix formation, the BEs are time-varying in most cases. The parameterized model is thus built and estimated along each range line. To validate the proposed method, two mountainous test sites located in China (i.e., Fuping in Shanxi province and Hetang in Hunan province) were selected. The obtained results show that the orbital phase errors of the bistatic interferograms over the two test sites are well estimated. Compared with the widely applied polynomial model, the residual phase corrected by the proposed method contains little undesirable topography-dependent phase error, and avoids unexpected height errors ranging about from −6 m to 3 m for the Fuping test site and from −10 m to 8 m for the Hetang test site. Furthermore, some fine details, such as ridges and valleys, can be clearly identified after the correction. In addition, the two components of the orbital phase error, i.e., the residual flat-earth phase error and the topographic phase error caused by orbital error, are separated and quantified based on the parameterized expression. These demonstrate that the proposed method can be used to accurately estimate and mitigate the orbital phase error in TanDEM-X bistatic InSAR data, which increases the feasibility of reconstructing high-resolution and high-precision DEM. The rigorous geometric constraint, the refinement of the initial baseline parameters, and the assessment for height errors based on the estimated BEs are investigated in the discussion section of this paper.

28 December 2022 in Remote Sensing
Verified
Journal Article
Open access
PDF file
LWLei Wang
Lei Wang
YZYushan Zhou
Yushan Zhou
GSGaoyun Shen
Gaoyun Shen
JXJunnan Xiong
Junnan Xiong
SHShi Hongtao
Shi Hongtao
The interferometric synthetic aperture radar (InSAR) technique based on time–frequency (TF) analysis has great potential for mapping the forest canopy height model (CHM) at regional and global scales, as it benefits from the additional InSAR observations provided by the sublook decomposition. Meanwhile, due to the wider swath and higher spatial resolution of single-polarization data, InSAR has a higher observation efficiency in comparison with PolInSAR. However, the accuracy of the CHM inversion obtained by the TF-InSAR method is attenuated by its inaccurate coherent scattering modeling and uncertain parameter calculation. Hence, a new approach for CHM estimation based on single-baseline InSAR data and sublook decomposition is proposed in this study. With its derivation of the coherent scattering modeling based on the scattering matrix of sublook observations, a time–frequency based random volume over ground (TF-RVoG) model is proposed to describe the relationship between the sublook coherence and the forest biophysical parameters. Then, a modified three-stage method based on the TF-RVoG model is used for CHM retrieval. Finally, the two-dimensional (2-D) ambiguous error of pure volume coherence caused by residual ground scattering and temporal decorrelation is alleviated in the complex unit circle. The performance of the proposed method was tested with airborne L-band E-SAR data at the Krycklan test site in Northern Sweden. Results show that the modified three-stage method provides a root-mean-square error (RMSE) of 5.61 m using InSAR and 14.3% improvement over the PolInSAR technique with respect to the classical three-stage inversion result. An inversion accuracy of RMSE = 2.54 m is obtained when the spatial heterogeneity of CHM is considered using the proposed method, demonstrating a noticeable improvement of 32.8% compared with results from the existing method which introduces the fixed temporal decorrelation factor.

21 January 2022 in Remote Sensing
Verified
Journal Article
Open access
PDF file
YZYushan Zhou
Yushan Zhou
XLXin Li
Xin Li
DZDonghai Zheng
Donghai Zheng
XZXiaolong Zhang
Xiaolong Zhang
YWYingzheng Wang
Yingzheng Wang
Yanlong GUOYanlong GUO
Yanlong GUO
The response of lake-terminating glaciers to climate change is complex, and their rapid changes are often closely linked to glacial-lake outburst floods. However, the eastern Tanggula Mountains, which are the only area where lake-terminating glaciers are found within the Tibetan Plateau, have received little attention to date. In this study, to address this gap, we generated updated glacier boundaries and estimated the interdecadal area changes for 2000–2020 based on the interpretation of Landsat-5/8 and Sentinel-2 images. In addition, based on the method of digital elevation model (DEM) differencing, we quantified the changes in glacier thickness and mass balance using TanDEM-X radar data and SRTM DEM over almost the same periods. The final results show that the glaciers in the eastern Tanggula Mountains, as a whole, have experienced accelerated area shrinkage (with a rate of area loss increasing from −0.34 ± 0.83 km2 a−1 to −0.93 ± 0.81 km2 a−1 for 2000–2013 and 2013–2020, respectively) and accelerated ice thinning (changing from −0.19 ± 0.05 m a−1 and −0.53 ± 0.08 m a−1 for 2000−2012 and 2012–2020, respectively). Furthermore, the region-wide glacier mass balance was −0.16 ± 0.04 m w.e. a−1 and −0.45 ± 0.07 m w.e. a−1 for these two sub-periods, corresponding to a 1.8 times acceleration of mass loss rate. The average mass balance during 2000–2020 was −0.23 ± 0.04 m w.e. a−1, which is equivalent to a rate of mass loss of −0.04 Gt a−1. More specifically, within the region, the lake-terminating glaciers have exhibited more significant acceleration of area loss and mass loss, compared to the land-terminating glaciers. However, interestingly, the average thinning rate of the lake-terminating glaciers is always lower than that of the land-terminating glaciers over all study periods, which is in contrast with previous findings in other high mountain areas (e.g., the Himalaya Mountains). Field study and proglacial lakes monitoring suggest that the local topography plays a vital role in the evolution of the glacial lakes in this region, which further affects the glacier changes. Furthermore, the present status of the glacier changes in this region can be attributed to the long-term increase in air temperature. Our findings provide a comprehensive overview of the current state of glacier changes across the eastern Tanggula Mountains and will help to improve the understanding of the heterogeneous response of glaciers to climate change.

12 February 2024 in IEEE Geoscience and Remote Sensing Letters
Verified
Journal Article
Closed access
YZYushan Zhou
Yushan Zhou
MDMeng Duan
Meng Duan
The DEM differencing method has been widely used for quantifying land surface change, especially in the field of glacier mass change. However, when the global DEM datasets are used to estimate large-scale glacier changes, the superposition effect of multi-source errors makes it difficult to remove the errors in the differencing maps using the existing method based on manually supervised correction. In this letter, to solve this issue, we propose a new stepwise correction method with an adaptive data partitioning strategy. The first step is to perform global spatial detrending, followed by global coarse co-registration. Subsequently, an initial data partitioning scheme based on the quadtree partitioning technique and relying on terrain slope is proposed. Furthermore, a parameter, i.e., the standardized standard deviation based on elevation changes, is used to further update the partitioning scheme. Finally, for each segmented data block, local spatial detrending is performed, followed by precise local co-registration. The proposed method was tested in the Pamir Plateau and the Tianshan River valley, based on the SRTM C-band and X-band DEMs and the Copernicus DEM. The final results show that the various types of error can be automatically and effectively removed, and that the normalized median absolute deviation and long-range correlation variance in ice-free areas shows an improvement of 10% and 24%, and 37% and 60% for the two study regions, respectively, demonstrating the good performance of the proposed method.