In this paper, a measurement system for human joint movements monitoring based on a simple and low-cost intensity modulated fiber-optic curvature sensor is presented. The implemented curvature sensor is made up of a plastic optical fiber, which is optimized for small curvature measurements, and has a high sensitivity in a wide measuring range. The sensor sensitivity and resolution, in the measurement range, are 20 mV/° and 1°, respectively. The fabrication process of proposed curvature sensor is also given. The implemented sensor is wearable, noninvasive, nonintrusive, and completely harmless. In this paper, the characteristics of the sensor measured in laboratory conditions as well as measurements of the human knee joint movements are given. Wireless electronics based on ZigBee are also presented. Therefore, the sensor has the possibility of wireless measurement. The main advantages of this sensor are simplicity, lightness, and flexibility. This sensor is also electrically safe and immune to electromagnetic interference. The application, which provides a possibility of remote human joints monitoring over the internet is implemented in the LabVIEW software package.
A method is proposed for predicting the evolution of the power distribution along graded-index plastic optical fibers. This method is verified against our recently reported measurements. The strong influence of mode coupling on the power distribution is demonstrated on a specific graded-index plastic fiber to illustrate the influence of mode coupling in applications, such as data transmission, power delivery, and sensing systems.
1 October 2012 in Sensors and Actuators A: Physical
Using the power flow equation and experimental measurements, investigated in this paper is the state of mode coupling in low NA (0.3) step-index (SI) plastic optical fibers under varied temperature. Numerical results obtained using the power flow equation agree well with experimental measurements. It is found that elevated temperatures of low-NA SI plastic optical fibers strengthened mode coupling. These properties remained after a year, with the fiber being subjected to environmental temperature variations of >35 K. These thermally induced changes of the fiber properties are attributed to the increased intrinsic perturbation effects in the PMMA material at higher temperatures. This results in an increase of the measured bandwidth with increasing fiber temperature as well as earlier the bandwidth switch from the functional dependence of 1/z to 1/z 1/2 (slower bandwidth decrease).