In this study, the thermal and mechanical properties of Cu50−xZr43Al7Agx (x = 0, 3, 4, 5, 6) bulk metallic glasses (BMGs) are investigated by using an X-ray diffractometer (XRD), a differential scanning calorimeter (DSC), differential thermal analysis (DTA), a Vickers hardness tester, a material test system (MTS), scanning electron microscopy (SEM), and transmission electron microscopy (TEM). Cu50−xZr43Al7Agx (x = 0, 3, 4, 5, 6) BMGs were made by arc-melting and an injection casting process. The results revealed that the glass transition temperature (Tg) and the crystallization temperature (Tx) of CuZrAl alloy decreased with the Ag addition. Hence, the supercooled liquid region and γ of Cu45Zr43Al7Ag5 alloy increased to 76 K and 0.42, respectively. The thermal stability and glass forming ability of CuZrAlAg BMG alloys were enhanced by the microalloyed Ag content. The room temperature compressive fracture strength and strain measured of Cu47Zr43Al7Ag3 were about 2200 MPa and 2.1%, respectively. The distribution of vein patterns and the formation of nanocrystalline phases on the fracture surface of Cu47Zr43Al7Ag3 alloy can be observed by SEM and TEM to be significant, indicating a typical ductile fracture behavior and an improved plasticity of alloys with the addition of microalloyed Ag from 0 to 6 atom %.
To provide a suitable microstructure and mechanical properties for modified Grade 440A martensitic stainless steel (MSS), which could facilitate the further cold deformation process (e.g., cold rolling), this work used differential scanning calorimetry (DSC) and Thermo-Calc software to determine three soaking temperatures for annealing heat treatment processes (HT1, HT2 and HT3). To verify the feasibility of the proposed annealing heat treatment processes, the as-received samples were initially heated to 1050 °C (similar to the on-line working temperature) for 30 min and air quenched to form a martensitic structure. The air-quenched samples were then subjected to three developed annealing heat treatment conditions. The microstructure and mechanical properties of the heat-treated samples were then investigated. Test results showed that considering the effects of the microstructure and the hardness, the HT1, the HT2 or the soaking temperatures between the HT1 and HT2 were the most recommended processes to modified Grade 440A MSS. When using the recommended processes, their carbides were fine and more evenly distributed, and the microhardness was as low as 210 Hv, which can be applied to the actual production process.